资源列表
EXRAM
- C5402外部RAM设计，板卡可能不同，但具有一定的参考价值-C5402 design of the external RAM, the board may be different, but with some reference value
digital-clock-
- 本代码采用verilog HDL语言编写。实现的是数字跑表计时功能-The code using verilog HDL language. Implementation is a digital stopwatch timer functions
ExInt
- C5402外部中断设计，板卡可能不同，但具有一定的参考价值-C5402 external interrupt design, boards may be different, but with some reference value
123
- 智能车的测速程序，用于智能车的脉冲测速，不过要和硬件配套使用-Intelligent vehicle speed program for intelligent vehicle speed pulse, but to supporting the use of hardware and
traffic-light
- 本代码是用verilog HDL编写，实现的是十字路*通灯的控制-The code is written using verilog HDL, to achieve the control of traffic lights crossroads
led_flash
- C5402板卡小灯测试程序，利用了定时器，可能具体板卡不同，但可提供参考-C5402 board a small lamp test procedure, and use the timer, may be different from the specific board, but can provide a reference
KEY
- C5402板卡键盘测试程序，可能具体板卡不同，但可提供参考-C5402 board keyboard test program, the specific board may be different, but can provide a reference
arm-linux
- 有关ARM嵌入式开发的资料，对学习嵌入式开发有所帮助。-For information on ARM embedded development, embedded development help in learning.
cc2430_ultrasonic
- Chipcon公司的CC2430 SoC上的超声波测距程序，编译器用的是IAR 730B for 8051。程序中的延时准确，已用示波器测试过了。-Chipcon' s CC2430 SoC ultrasonic distance measurement on the program, the compiler is IAR 730B for 8051. Accurate delay the program has been tested with an oscilloscope befo
asmled
- 用外部中断控制P1口外接8只灯闪烁。要求：P1口外接8只灯作左移循环点亮，当外中断发生时，作交叉闪烁4次后再左右闪动4次后回到循环左移点亮状态-P1 port interrupt control with external add-eight light flashes. Requirements: P1 port for external 8 lamps light up the left loop, when the external interrupt occurs, for cross
cc2430
- 在IAR 8051上面开发的Chipcon公司的CC2430的12864液晶驱动及测试程序。液晶采用串行连接。-Developed on the IAR 8051 Chipcon' s CC2430' s 12864 LCD driver and test procedures. LCD serial connection.
clock
- 基于单片机AT89S52 时钟芯片 DS12887的 万年历的设计-AT89S52 microcontroller-based perpetual calendar clock chip design DS12887