资源列表
esign
- 基于单片机的CAN_PROFIBUS_DP总线桥的设计-CAN_PROFIBUS_DP bus bridge based on single chip design
shumadisplay
- 一种用verilog写的数码显示程序，编译通过，可下载到fpga中-program of shumadisplay,write by verilog language
include
- 1、本程序用于测试4相步进电机常规驱动 2、需要用跳帽或者杜邦线把信号输出端和对应的步进电机信号输入端连接起来 3、速度不可以调节的过快，不然就没有力矩转动了 -1, the procedure used to test the conventional 4-phase stepper motor driver 2, need to use DuPont wire jumper or the signal output and the corresponding stepper
fir_filter
- 一种fir滤波器的verilog程序，非常实用-fir filter very good write by verilog
C
- 单片机控制继电器，用杜邦线把继电器输入端口和P1.1连接起来 按键s1吸合 s2释放继电器-SCM control relay, the relay with the DuPont line connecting the input port and P1.1 pull s1 s2 key release relay
Remoteway
- 面向UUV遥操纵系统的网关设计Remote control system for UUV' s Gateway-Remote control system for UUV' s Gateway
TestUart
- PIC单片机实现串口驱动的简单实例，可扩展串口代码。-PIC MCU serial driver simple example can be extended serial code.
SSI
- TI CORTEX M3 SSI驱动8位数码管源程序-DRIVE 8 BIT
1
- 本程序控制DSP的CAN通信,DSP型号为dsp f2812-The program control DSP' s CAN communications, DSP model dsp f2812
dead-PWM
- TI CORTEX M3微控制器死区PWM-DEMO DEAD PWM
SLEEP
- TI CORTEX M3微处理器睡眠模式程序-SLEEP DEMO PROGRAM
diffrential
- TI CORTEX M3 ADC差分输入采样-ADC DIFF