资源列表
Te
- 实现宽带信号放大，由AD603级联组成增益放大器，实现增益 -20～60dB 范围内可按5dB步进调节或连续可调，且在0～9MHz通频带内增益起伏在1dB以下 互补三极管射级跟随高功率输出在50 负载上最大输出电压有效值Vo≥10V,波形无明显失真 功放输出信号经有效值检波后，通过10位A/D转换芯片TLC1549，将模拟电压的有效值转换成数字信号，并送微控制器实现增益预置与显示。-Broadband signal is amplified by the AD603 gain am
TouchDemoPP
- LCD example for TE-LPC2478LCD5.6 board
elev
- 电梯verilog代码，6层楼的，里面有电路图也有芯片类型-code of elevator verilog
test01
- 利用状态机编写的流水灯的VHDL程序源代码，基于xilinx公司的spartan3E入门级开发板。-Water prepared by a state machine VHDL source code lights, based on the company s spartan3E xilinx entry-level development board.
PCI_T32
- PCI-32转local bus-PCI-32 switch to local bus!!!!!!!!!!!!!!!!!!!!!!!
microchipn-PT100-0.01
- microchip公司工程师设计的PT100应用的文档，精度可以达到0.01度-PT100 microchip company engineers designed the application documents, the accuracy can reach 0.01 degrees
LPC213X-SPI-LCD12864-CPP
- LPC213X模拟SPI之LCD12864 C++代码-LPC213X simulation SPI of LCD12864 C++ code
modbus-study
- 基于单片机的MODBUS总线协议实现技术研究-Microcontroller-based technology research protocol MODBUS bus
LPC2148-UCOS
- ARM7 LPC2148 μCOSII 的移植代码-ARM7 LPC2148 μCOSII of portable code
Single-Chip
- 单片机测电容实验，根据电容所在电路震荡出的频率计算电容。-SCM capacitance measurement experiment, where the circuit under the capacitance calculation of oscillation frequency of the capacitor.
ARM2148-UART0
- ARM7 LPC2148 在ADS环境下编译的 UARTO 串口程序 -ARM7 LPC2148 under the ADS program compiled UARTO serial
ARM2148-I2C
- ARM7 LPC2148 在ADS 环境下编译的 I2C协议 带详细注释源程序 附带原理图-In the ADS environment ARM7 LPC2148 I2C protocol source code compiled with the schematic