资源列表
Project
- sample code mcf5329 develoment board.
ZigBee-stack2.0
- zigbee协议栈源代码。可以配合2420收发器使用-zigbee protocol stack source code. Transceiver CC2420 can be used
FPGA_FIR
- 基于FPGA的FIR滤波器的源代码，经测试完全正常。-FPGA-based FIR filter' s source code, the test is normal.
nios2_timer
- 在NiosII IDE下的编写的一个显示时间的程序-In NiosII IDE written under the procedures of a display time
dianziyindiao
- 单片机电子音调发生器，可以播放7种音调，2首音乐，调试已通过-SCM electronic tone generator, tone can play 7, 2 music, commissioning has passed
uCOS286
- uC/OS移植到F2812上全代码，经测试完全正常。-uC/OS port to F2812, on the whole code, the test is normal.
DSP
- SEED_DSP 开发板测试程序，包括 FLASH读写和操作各种外设-seed_dsp test program，R&W flash，and external interface
multisim
- 基于Multisim软件设计的数字秒表电路课程设计报告-Multisim software design based on digital stopwatch circuit course design report
weiji
- 声-光报警程序 运行步骤:1.按下一次开关SW3,开始声-光报警,再按下一次则停止 重复上述操作* 2.按下"q"或者"Q",退出 -Sound- light alarm program* run these steps: 1. Press a switch SW3, began to sound- and light alarm, and then press again to stop Repeat* 2. Press the " q" or &
I2C
- sample I2C interface with a Microchip 24LC16 serial EEProM
pingpang
- 模拟乒乓球游戏机，输入有按键消抖模块，利用两个七段数码管的其中9段来模拟乒乓球的移动路线，中间的数码管兼做球网。-Table tennis simulation game, enter a key debounce module, using two seven-segment digital tube to simulate the Table Tennis section 9 of the mobile line, cater to the middle of the digital net
VxWorks
- 讲述了VxWorks的所有命令及使用方法-VxWorks about all the commands and how to use