资源列表
direc_motor(done)
- 直流电机驱动，在lpc2000些列开发板上的-DC motor drive, the more out lpc2000 development board
ISD1720subprogram
- 基于STC12C5410单片机的ISD1720语音芯片的应用子程序，已成功应用。-Based STC12C5410 ISD1720 voice chip microcontroller application subroutine has been applied successfully.
DemSNT_Server
- The user will enter the client number, then each client will send 2 server number from 0 -> 10. The client sends alternate: client 1 sends the first client sends the first two, turn to the last client. Continue for 2 times: client 1 send a s
uart
- arm2410 串口驱动改编 uart serial.c-arm2410
rf2401
- rf2401的驱动，包括1138开发板上的，和lpc2000系列（lpc2131，lpc2132），测试通过 -rf2401 drive, including the 1138 development board, and lpc2000 series (lpc2131, lpc2132), tested
fir
- 有限冲击相应FIR滤波程序，CCS5000调试通过-FIR filter
dingdianchufa
- 定点除法程序及执行结果截图 CCS5000调试通过 -ding dian chu fa
kuaisufuliyebianhuan
- 快速傅里叶变换程序 CCS5000调试通过-fast Fourier transform
nRF401_test
- nfr401测试源码，主要在是无线模块在51单片机上的测试源码-nfr401 test source, mainly in the 51 single-chip wireless module on the test source
can-node-communication
- 该程序已经被多次使用，需要两个sja1000 + 51 + pca82c250的通讯模块（本程序是在P2.6和P2.5设置了LED灯来显示是否通讯成功），将源程序（kaobei.hex）下载到51单片机中，上电后通过按下两个模块的复位键，就能看到对应的模块有指示灯显示-The program has been used many times require two sja1000+ 51+ pca82c250 communication module (the program is set in
LEDdongtaixianshi
- 利用动态扫描方法在六位数码管上显示出稳定的654321. 时钟频率为11.0592M-Dynamic scan of the six digital control on the show stable 654 321. Clock frequency 11.0592M
fengmingqi
- 同时用两个定时器控制蜂鸣器发声， 定时器0控制频率，定时器1控制同个 频率持续的时间，间隔2s依次输出 1，10，50,100，200,400,800, 1k（hz）的方波? 设晶振频率为12MHz。-At the same time the buzzer sound with two timers, Timer 0 control the frequency of Timer 1 control with a frequency, duration, interval 2s