资源列表
hitechug
- hi-tech picc 编译器用户指南，只针对pic10、20 16系列-hi-tech picc compiler User' s Guide, only for pic10, 20 16 Series
picc
- pic 单片机hitech picc，应该是目前能在网上收集到得较全得picc学习资料了-hi-tech picc
Remote_IO
- Modbus Remote IO for 8051
frequency_counter2
- 频率计，通过单片机 CPLD共同实现对输入方波信号测频率，测量范围1—10Mhz，带数码管译码显示-Frequency counter, through the joint realization of single chip CPLD input square wave signal measured on the frequency, measurement range 1-10Mhz, with a digital display control decoding
UV3
- 中文uVision3帮助文档，挺详细的需要学习的下了看。-uVision3 help
ADC0809
- 采样显示.ADC0809与C51的原代码， 是用C语言编写的，供大家学习参考！-Sample Display. ADC0809 and C51 of the original code is written using C language for them to learn information!
2
- 一个共阴极数码管显示从000000加1到-A common cathode LED display plus 1 to 999,999 from 000,000
myled
- 基于NIOSII的led驱动程序，包含FPGA的硬件设计部分和软件设计部分-Based NIOSII' s led driver, the hardware design part contains the FPGA and software design
mybutton
- arm9在linux系统下的按键驱动，采用中断方式，并包含其qtopia应用程序-arm9 the key driver under linux system using interrupt mode, and includes the qtopia application
gpio
- liunx系统下，mini2440的底层IO驱动，并包含IO测试程序-liunx systems, mini2440 underlying IO driver, and test procedures include IO
18b20
- 基于嵌入式linux的温度传感器DS18B20的驱动程序，和测试程序-Temperature sensor based on embedded linux DS18B20 drivers, and test procedures
AnalogSwitchesLightProgram
- 监视开关K1（接在P3.0端口上），用发光二极管L1（接在单片机P1.0端口上）显示开关状态，如果开关合上，L1亮，开关打开，L1熄灭。-Monitor switch K1 (connected to the P3.0 port), with a light-emitting diode L1 (P1.0 port connected to the MCU) shows off state, if the switch is closed, L1 light, the switch opens,