资源列表
EduKit2410_for_MDK
- reilciew MDK 实例大概有20个，关于Embest箱子的-reilciew MDK instance about 20, on Embest boxes
My_Flash
- 开发的硬件是MCF52233开发板。程序主要是写在开发板上控制FLASH编程。-Developed hardware is MCF52233 development board. Procedures mainly written development board control FLASH programming.
MCF52234_uCOS-II
- 这是由MFC52234开发板开发的程序，它是由ucOS到MCF52234上的移植和应用。-This is MFC52234 development board developed program, It consists ucOS to MCF52234 on transplant and applications.
traffic_lights_control
- 这是用MFC5213DEMO开发板，在MCF5213上写的交通灯控制系统，演示效果挺好-This is MFC5213DEMO development board, in MCF5213 write traffic lights control system, presentation effect very good
programme
- dsp2812 练习程序,包括液晶，led,232通讯，485通讯等，还有些有用的算法-dsp2812 exercises procedures, including LCD, led, 232 communications, 485 communications also some useful algorithm
motioncontrol
- 这是一个采用FPGA实现PCI接口的运动控制卡，全部实现的论文资料-control
123
- Windows+CE驱动程序开发指南,为wince下编写驱动提供指导-Windows+ CE Driver Development Guide, prepared for the drive to provide guidance wince
C
- 嵌入式开发的好书，不过英语好的才看的了。-
UBootFlashProgramming
- atrm9200 板子的ubootflash启动-atrm9200 board of ubootflash start
EBD_ARM9200-GettingStarted-ADS1_2-1_1
- EBD_ARM9200-GettingStarted-ADS1_2-1_1 这是我正在学习的嵌入式开发资料-EBD_ARM9200-GettingStarted-ADS1_2-1_1 This is what I was learning the information embedded development
experiment6
- VHDL课程实验6，数控分频器的设计。对应不同的输入信号，预置数（初始计数值）设定不同的值，计数器以此预置数为初始状态进行不同模值的计数，当计数器的状态全为1时，计数器输出溢出信号。用计数器的溢出信号作为输出信号或输出信号的控制值，使输出信号的频率受控于输入的预置数-VHDL course experiment 6, NC Divider. Corresponding to different input signals, the set value (initial count) to set
c
- 单片机C语言入门，本文通过一系列的 实例介绍C 语言编程的方法，很实用，适合初学者。-Introduction to C language SCM