资源列表
bootc
- BOOT c语言启动代码实现设置好硬件的起始状态-BOOT c language startup code to achieve the starting state set up the hardware
s3c44b0
- 基于三星S3C44B0ARM7的开发板电路图-The development board based on Samsung S3C44B0ARM7 circuit
S3C2410
- 基于三星S3C2410ARM9的开发板电路图-The development board based on Samsung S3C2410ARM9 circuit
51-series
- 利用51/52两个管脚实现串口通讯的C语言程序-The use of two pins 51/52 Serial Communication
UCOSII
- 基于三星2410UCOSII的几个演示程序-Samsung 2410UCOSII based on a few demo program
temperature_control
- 51接7279的温控程序，精确到小数点后2位，可实现上下限温报警-51 Access 7279 temperature control procedures, accurate to two decimal places, can be realized on the lower limit temperature alarm
count_2
- 用51单片机实现2路实时计数，并通过串口返回计数值-51 MCU with 2-way real-time count, and count back through the serial port
DEC6713_GPIO_bootloader
- 以TMS320C6713为例，设计bootloader程序，有可测量的标志信息-To TMS320C6713, for example, the design bootloader program, there are measurable signs of information
DEC6713_GPIO_bootloader
- 以TMS320C6713为例，设计bootloader程序，其中包括可测量标志-To TMS320C6713, for example, the design bootloader program, including measurable signs
dec6713_gpio
- TMS320C6713处理器中GPIO的使用，包括配置和使用-TMS320C6713 processor GPIO usage, including configuration and use of
DEC6713_Timer
- TMS320C6713中定时器的使用，包括外部时钟和内部时钟的使用-TMS320C6713 timer in use, including an external clock and internal clock using the
uart
- 通过TMS320C6713B来控制UART芯片，和电脑进行通信-TMS320C6713B to control the UART through the chips, and computers to communicate