资源列表
memmp
- 完成对LPC2290的地址重映射。并通过锋鸣器提示操作是否完成。也可以通过通过ADS软件观测存储器的变化-LPC2290 completion of the re-address mapping. By Feng-ming on whether a prompt completion. Can be passed through observation memory ADS software changes
mcg12864interface
- 液晶屏MCG12864的接口程序,它由两片KS0108组成,包括寄存器读写等-MCG12864 the LCD screen interface, which consists of two components KS0108, Register including reading and writing, etc.
DE2_Default
- his design is the initial design when the board is powered-up. It increments a counter and displays the value on the 7-segment displays and LEDs. An image is also displayed on the VGA port.-his design is the initial design when the bo ard is powere
ds12887interface
- 时钟芯片DS12C887的接口程序,包含读,写时钟和里面的自带存储器-Clock Chip DS12C887 interface procedures, including reading, writing and the clock inside of bringing their memory
DE2_SD_Card_Audio
- This designs uses a Nios II system to demonstrate how to read from the SD card. The software reads WAV files from the SD card and plays it through the LINE OUT line. Simply put a SD card into the slot on the board and connect some speakers to the LIN
Pwm8
- C8051F020的PWM程序FYD12864显示-C8051F020 PWM procedures FYD12864 show
v_pid
- 使用ICCAVR编辑，配合MCU1使用。 主要进行了增量式光电编码器的脉冲读取，PID控制的头文件-use ICCAVR editors, with MCU1 use. A major incremental optical encoder pulse reading, PID control of the header files
MCU2PID
- 使用ICCAVR编辑，配合MCU1使用。 主要进行了增量式光电编码器的脉冲读取，PID控制-use ICCAVR editors, with MCU1 use. A major incremental optical encoder pulse reading, PID control
MCU1
- 使用ICCAVR编辑，实现直流电机的控制和调速，配合MCU2使用，之间用串口调试-use ICCAVR editor, the realization of DC motor control and speed, with MCU2 use, Serial debugging used between
Proteus_DCMotor
- Proteus下进行直流电机的仿真文件 配合DC_Motor.c使用-Proteus under Motor simulation files with the use of DC_Motor.c
st7_can
- st7单片机关于can总线设计的源程序,使用ST7单片机的很有用-st7 microcontroller on the bus can design source, the use of ST7 MCU useful
DC-Motor
- 直流电机驱动，实现直流电机的正、反转，PWM调速-DC motor-driven, achieving Motor and down, PWM Speed Control