资源列表
fet440_wdt01
- MSP-FET430P440 Demo - WDT Toggle P5.1 Interval overflow ISR, DCO SMCLK-MSP-FET430P440 Demo - 14d Toggle P5.1 Inte rval overflow ISR, the making of SMCLK
fet440_uart11_38400
- MSP430F449 子程序,MSP-FET430P440 Demo - USART1 UART 38400 Echo ISR, DCO SMCLK.-MSP430F449 subroutine, MSP-FET430P440 Demo-USART1 UART 38400 Echo IS R, the making of SMCLK.
pic_nibian
- 采用PIC单片机控制的逆变器的源程序，包括产生PWM波形。-using PIC microcontroller control of the inverter source, including generating PWM waveform.
I2C_altera
- I2C的说明!基于FPGA的I2C总线控制核设计,大家帮忙-I2C Note! FPGA-based nuclear I2C bus control design, we look at the help
C51DEBUG
- 用51单片机实现IR解码，I2C驱动，EEPROM读写。-MCU with 51 IR decoding, I2C-driven, EEPROM read and write.
CANBus-echo-V7.x
- DSP56F807的CAN通讯程序,可用于多子板互连、也可作为开发的原型程序-DSP56F807 CAN communication procedures can be used for many sons and Backplane, can also be used as the prototype development process
serialdiversforVxworks
- 基于VxWorks系统串行驱动.详细介绍了串口的驱动开始和编程的过程.-system based on VxWorks Serial Drivers. Details on the serial port driver and began the process of programming.
s3c2410.c
- 本源码是对三星S3C24xx系列的UART的驱动程序.-the source of Samsung S3C24xx series of UART driver.
AN_SPMC75_0001
- 凌阳单片机采用vvvf（变压变频)开环驱动交流电机-Sunplus vvvf using SCM (VVVF) open-loop-driven AC motor
LPC900_hongwai
- 利用LPC900系列单片机的UART和CCU模块实现红外通信. * 此程序为从机程序,当接收到16字节数据后,再把接收的数据 * 返回给主机.-use LPC900 Series and the UART CCU infrared communications module. * This procedure from the plane procedure, when received 16 byte data, and then receiving the data back to
LPC900_hongwai_2
- 利用LPC900系列单片机的UART和CCU模块实现红外通信. * 此程序为从机程序,当接收到16字节数据后,再把接收的数据 * 返回给主机.-use LPC900 Series and the UART CCU infrared communications module. * This procedure from the plane procedure, when received 16 byte data, and then receiving the data back to
8139-p4
- RTL81x9在VXWORKS下的驱动程序，适用于奔4的目标机及奔4PRO（待测），可直接挂载-RTL81x9 in the Ethernet driver, Ben apply to the four target machine and Ben 4 PRO (unknown), direct mount