资源列表
点对点串行通信
- 用于串口通信的源代码 用c编程的程序 希望对大家有用-for serial communication with the source code c programming procedures hope useful for all
time123456
- 智能计数器，对外部信号脉冲进行计数，并将脉冲个数显示出来。 基本要求：计数至少65536个脉冲，并将脉冲个数显示出来。 -intelligent counter, the external signal pulse counting, pulse number will be displayed. Basic requirements : at least 65,536 Count pulse, and pulse number displayed.
jtag_gdbserver_20060621.tar
- The \"JTAG-GDB server\" is a program for integrating the ARM-Embedded ICE logic with the GNU-Debugger GDB. -The "JTAG-GDB server" is a program for INTE grating the ARM - Embedded ICE logic with the GNU - GDB Debugger.
gdb-jtag-arm.tar
- GDB Remote Stub Backend for debugging an embedded ARM system via JTAG common hardware debug interface. Communication is done via standard TCP/IP GDB Remote Serial Protocol. -Remote Stub Backend GDB for debugging an em bedded ARM JTAG system via commo
colorSend
- 大厦LED流水显示的程序，刚刚编完，可通过修改循环的次数和数据表来构成不同的显示效果-LED shows the procedure, the newly produced, cycle through changes in the number and composition of data tables show different results
51-system
- 51上运行的实时操作系统,原代码，有详细说明．-51 running real-time operating system, the original code is described in detail.
tms320c54x-example
- TMS320C54X DSP 实验指导程序 实验一 常用指令实验 实验二 数据存储实验 实验三 I/O实验 实验四 定时器实验 实验五 INT2中断实验 实验六 A/D转换实验 实验七 D/A转换实验 实验八 AD/DA综合实验 -TMS320C54X DSP experimental procedures to guide an experimental common directive experimental experimental data sto
keyenter
- 这是一个单片机键盘响应程序，主要用于单片机设计中对键盘的编程，使得单片机能够显示键盘的按键-This is a microcontroller keyboard response procedures, mainly for the design of single-chip microcomputer keyboard programming, SCM makes the keyboard can display buttons
Exp4-Clock
- 数字计时器，使用VHDL语言编写，使用数码管显示，精确到ms-digital timer, the use of VHDL development, the use of digital control, the precision of the ms
FullAdder
- 四位全家器的VHDL语言模块，已经在ISE8.1上经过测试通过-family of four VHDL modules, has been tested on ISE8.1 through
FourBitsCounter
- 四进制计数器模块，使用VHDL语言编写，在ISE8.1中经过测试的模型-quaternary counter module, the use of VHDL language, in which ISE8.1 tested model
FTCTRL
- 四位十进制频率计的顶层控制模块，用于生成测频需要的复位及控制信号-four decimal frequency of top-level control modules, used to generate the required frequency measurement and control signals reset