资源列表
1.LED
- 单片机实训用8051单片机实现LED亮灭控制-MCU training with 8051 single chip microcomputer LED control
51UART-of-example
- 1、根据接收到的命令帧执行响应的动作 2、串口接收监控，由空闲时间判定帧结束 3、执行命令后，数码管对应显示-1, according to the received command frame perform the appropriate action 2, serial port to receive monitoring, idle time is determined by the end of the frame 3, after executing the comm
STC12-duoji
- 基于STC12单片机自带PCA/PWM控制舵机转动角度-Based on STC12 MCU PCA/PWM control steering angle of steering gear
xilinx_PCIeLogiCore
- 基于xilinx fpga的PCIE逻辑IP核-thisis a xilinx_PCIeLogiCore
STC12--pinlvji
- 基于STC12单片机的自带AD采集并1602液晶显示；频率采集1602液晶显示程序。-Based on the STC12 microcontroller AD acquisition and 1602 LCD display frequency of 1602 LCD display program.
8051_code
- 8051 codes to interface pheripherals
Infrared-negative-solution
- 使用外部中断0连接遥控头，接收红外遥控键值送P1口显示，12MHz外部晶振-The use of external interrupt 0 is connected with the remote infrared receiving head, infrared remote control key delivery port P1 display, an external crystal oscillator 12MHz remote control decoding procedure
intelligent--car
- 智能小车利用超声波测量原理测量出前方障碍的距离，通过分析算法，独立判断行驶方向，避开前方障碍行驶-The intelligent car uses the ultrasonic measurement principle to measure the distance of the front obstacle, through the analysis of the algorithm, independently determine the direction of travel, to a
M24LR04E-R-discovery-board-1.3.1
- CR95HF st资料整理demo板 stm8软件-CR95HF st data compilation software demo board stm8
TunerUI
- FM Tuner(5B705)上层应用程序-Upper layer program of FM Tuner
ADC0804
- ADC0804模数转换实验 C51 C52 单片机程序 测试通过-ADC0804 analog to digital conversion experiments C51 C52 MCU program tested
2GSD
- 读2G SD卡（STC89C54或者RAM更大的单片机）写图片 测试程序 已通过-Read 2G SD card (STC89C54 or greater RAM MCU) write picture test program has passed