资源列表
KinetisIAR
- OSPF协议将网络划分为多个自治域进行管理，路由器根据在自治系统中的角色划分(IAR,ABR,BBR,ASBR)，除IAR外，一个运行OSPF协议的接口状态根据接口的不同类型可划分为 DR: Designated Router BDR: Border Designated Router DROther: Non (DR or BDR)-The OSPF protocol divides the network into several autonomous doma
unit4-homework
- 把8个LED接在单片机P1的端口上，这位就可以通过P1口来控制LED的亮灭了。至于定时功能要用到单片机内的定时器。-The 8 LED on the microcontroller P1 port, the P1 port to control the LED s light out. As for the timer function to use the microcontroller timer.
qiangdaqi
- 一般抢答器电路复杂，要通过仿真器、应用软件、计算机等辅助设备才能验证完成，对于初学者来说，显得有些力不从心。以下设计的这款电路非常简单，只要按图一试，就能装成一台简单的八路抢答器。-General Responder circuit complex. Through emulator, software applications and computer auxiliary equipment to verify complete, for beginners, appear some abil
MCS51UART
- 自己写的51单片机串行口与PC机通信程序，汇编语言实现-Write your own 51 microcontroller serial port and PC communication program, implemented in assembly language
UsartTest
- 使用ATmega16进行串口通信，编译环境为ICC AVR-uart conmunication used ATmega16 MCU,the develop environment is ICC AVR
NixieTubeWith74HC595
- 使用ATmega16单片机，并使用74HC595驱动8个8段数码管-Use ATmega16 microcontroller and use 74HC595 drive 8 8 digital tube
DS1302TEST
- 使用ATmega16驱动DS1302传感器，将测量的结果显示在数码管上-ATmega16 drive using DS1302 sensor, the measurement results are displayed on the digital tube
ADCtest
- ATmega16单片机的ADC功能演示，通过改变电位器的阻值可以看到测量结果的变化-ATmega16 microcontroller ADC functional demonstration, by changing the resistance of the potentiometer can see the change in the measurement result
leveltest
- ATmega16 示例工程，判断管脚高低电平，让LED灯亮或者灭-ATmega16 sample project, determine pin high and low, the LED lights or off
50hzled-xunhuan
- 50hz led灯循环闪烁 8个led-Led 50Hz lights cycle flashing 8 LED
vehicle_counter.tar
- 基于linux和C的ADC模块、串口和GPIO操作及软中断开发-linux and c based ADC module, serial port and gpio operation and signal process.
1.13.1304CAN-communication
- stm32f103c8t6单片机之间通过CAN总线通信的程序，主机可以为从机进行编号，从机独立上电，编号以时间为序。-CAN bus communication between stm32f103c8t6 SCM procedures, the host may be machine number, the slave independent power, numbered in chronological order..