资源列表
dz60
- freescale dz60 can source
SegLed_DynamDisp
- 这个是传统的fpga的入门代码，关于数码管的驱动代码，非常适合新手学习-This is a traditional fpga entry code on the digital control of the driver code, very suitable for novices to learn
myfpga
- 这个是经典的FPGA的相关的乘法器，除法器的代码，还有别的可用的资料，都是网络上攒的，并且真的是非常经典-This is a classic of the relevant multiplier divider FPGA code, as well as other available information, are saved on the network, and really is very classic
sdram_test
- 这个是经典的sdram的驱动代码，可能你需要留意下具体的芯片型号，我在里面都有介绍，已调可用，并且真的是非常经典-This is a classic sdram driver code, you may need to pay attention to the specific chip model, which I have introduced in the modulated available and really is very classic
adc0804
- 这个是经典的0804的ad传感器的驱动代码，已调可用，并且真的是非常经典-This is a classic ad sensor driver code 0804, the modulated available and really is very classic
DAC(tlv5618)
- 本设计是基于EP4CE15F17C8N和TLV5618的双路12位DAC模数转换和12864显示的程序-The design is based on a program EP4CE15F17C8N and TLV5618 Dual 12-bit DAC analog to digital conversion and display of 12864
DAC(tlv5616)
- 本设计是基于EP4CE15F17C8N和TLV5616的12位DAC模数转换和12864显示的程序-The design is based on a program of 12 EP4CE15F17C8N and TLV5616 DAC analog to digital conversion and display of 12864
ADS8323
- 本设计是基于EP4CE15F17C8N和ADS8323的16位ADC数据采集和12864显示的程序-The design is based on a program EP4CE15F17C8N and ADS8323 16-bit ADC data acquisition and display of 12864
HAL_drive_SHT1X
- 文件有HAL_drive_SHT1X.c和HAL_drive_SHT1X.h测试通过温湿度采集准确。-File has HAL_drive_SHT1X.c and HAL_drive_SHT1X.h tested collect accurate temperature and humidity.
ADS1118
- 本设计是基于EP4CE15F17C8N和ADS1118的ADC数据采集和12864显示的程序-The design is based on a program EP4CE15F17C8N and ADS1118 ADC data acquisition and display of 12864
NTC_Filter_code
- NTC_Filter_code是基于温度的一个平滑滤波算法，非常实用，在项目中经常会用到。-NTC_Filter_code is a smoothing algorithm based on temperature and very practical, often used in the project.
NTC_T_mcu_code
- NTC负温度系数ADC采集对应表代码，5V表和3V数据准确，误差在+1到-1之间，数据稳定。文件有NTC.C和NTC.H文件。-NTC negative temperature coefficient ADC codes correspond collection, 5V and 3V table data is accurate, error between+1 and-1, the data is stable. File has NTC.C and NTC.H file.