资源列表
ExtiKey
- 基于STM32，PB0连接到key1，PB0配置为线中断模式，key1按下时，进入线中断处理函数，LED1状态取反。-PB0 connected to key1, PB0 configured for line break mode, press key1 into line interrupt handler LED1 status negated.
NES
- 非常完整的arm7的汇编nes模拟器核心.-nes emulator compilation of core arm7
LED
- LED流水灯程序，可以实现安50分频的频率流水，文件中值包含了必要的.v文件，具体工程需要自己创建-LED light water program, can realize frequency water, Ann 50 points frequency value of the file containing the necessary. V file, need to create your own specific project
03_key_detect_1
- 键盘抖动的Verilog实现，设计的方法主要是由“电平检查模块”和“10ms延迟模块”组合合成。-Keyboard shaking Verilog implementation, the method of design is mainly by level examination module and 10 ms delay module combinatorial synthesis.
02_run_flash_led
- 在这一个实验，我们要以上图作为基础，建立一个并行操作的流水灯模块。扫描频配置定为100 Hz，而每一个功能模块在特定的时间内，将输出拉高。-In this experiment, we should above figure as the foundation, set up a parallel operation of flowing water light module. Scanning frequency configuration at 100 Hz, and each functi
SolarMicroInv_F2803x
- 这是TI公司的一个关于光伏并网的dsp程序。-This is a DSP program of TI company,which is used in grid-connecd of solar inverter.
AD9833
- ad9833 datasheet ad9833 datasheet-ad9833 datasheet ad9833 datasheet
i2cdevlib
- mpu6050 的函数库，可以实现dmp功能
motor
- 步进电机驱动源码（包含加减速，细分等功能）-Stepper motor driver source code (including acceleration and deceleration, subdivision and other functions)
STC12-18b20
- 基于STC12的18B20温度检测程序 屏幕为OLED12864 1.3寸-STC12 based 18B20 temperature detection program screen for OLED12864 1.3 inch
单片机SPI配置
- 自己编辑的单片机的SPI协议，可以拿来直接移植使用。
7-21-STC12
- stc12 接入屏幕自动检测波形峰峰值，波形斜率-STC12 access screen automatically detect the waveform peak, waveform slope