资源列表
tiaoma
- 用于实现外部设备与LPC的连接，虚拟串口的程序代码，用在条码扫描上-It used to connect external devices with the LPC, virtual serial code, used in bar code scanning
GPIO_LedBlinky
- NXP LPC177x 使通用GPIO 的方式控制电路板上的LED 闪烁 开发环境KEIL C-Using to mode of GPIO to contronl LED Blink on the PCB of LPC177X,NXP,The Development Environment is KEIL C
ADC_Polling
- NXP LPC177x 使轮询方式读取ADC 开发环境KEIL C-Using mode of polling to read ADC in NXP,LPC177X.The Development Environment is Keil c
Three-axis-accelerator-startup-code
- 该工程文件是利用SSI_v12软件编写的程序，实现利用单片机st20p18来读取STK8BA50_REV 0.9.1三轴加速度模块的数据。-File of this project is to use SSI_v12 software program, using single chip computer implementation st20p18 to read STK8BA50_REV 0.9.1 triaxial acceleration data module.
ADC_Interrupt
- NXP LPC177x 使中断方式读取ADC 开发环境KEIL C-Using mode of interrupt to read ADC in NXP,LPC177x.Development Environment is KEIL C
STM32BootLoader_USB_ZModem
- 一个基于STM32的Bootloadr,可以使用ZModem协议通过USB虚拟串口更新固件。-A Bootloadr based STM32, you can use the ZModem protocol USB virtual serial update firmware.
ADC_Dma
- NXP LPC177x 使DMA 方式读取ADC 开发环境KEIL C-Using mode of DMA to read ADC in the NXP LPC177X. Development Environment is Keil C
XC878_MultiCAN_05
- Infineon XC878平台 Multi-CAN編程範例程序(5)-Infineon XC878 platform Multi-CAN programming guide exam(5)
The-serial-communication
- 该程序是利用keil 5开发环境编写的，实现stm32F4开发板与pc的串口通信程序-The program is written using the keil development environment 5, realize stm32F4 development board with PC serial communication program
stemwin-tutorials-Chapter-58
- 安富莱电子推出emwin教程，共60期。论坛：http://bbs.armfly.com/本期教程讲解STemWin支持的SPINBOX控件。-Armfly Electronics launched emwin tutorials, a total of 60. Forum: http: //bbs.armfly.com/
code-final-bless
- STM8 interface with Hope RF module for AMR Energy Meter
XC878_MultiCAN_04
- Infineon XC878平台 Multi-CAN編程範例程序(4)-Infineon XC878platform Multi-CAN programming guide exam (4)