资源列表
MyGPIO
- 神舟3号开发板STM32F103 GPIO源码-SZ-3 development board STM32F103 GPIO source
WinGDB_0.59a
- winDBG window下的嵌入式调试软件-WinDBG embedded debug software under the window
USB_save
- 这是基于FPGA的USB通讯程序。通过在quartus中建立SOPC，建立PIO口，并在NIOS中写驱动和寄存器等，实现USB通信。经检验，该程序通信正常。-This is FPGA-based USB communication program. By establishing the quartus in SOPC, establish PIO mouth and NIOS to write drivers and registers, realize USB communications.
OV7620-image-acquisition-program
- 有关0v7620的图像采集程序，其中有些地方已经用中文或者英文标记出来了，具体内容自己看看吧-The image acquisition program on 0v7620, which in some places have used Chinese or English marked, the specific content of their own have a look.
edge
- 基于NIOS的硬件中断例程，该程序通过一个外部按键来验证一下中断凼数癿处理过程。所用的软件为quartus和nios。主要分为硬件开发及软件开发两部分。-Based on NIOS hardware interrupt routine, the program by an external button to verify that the interrupt number Taipa 癿 process. The software used for the quartus and nios.
CH376
- 用VERILOG HDL语言写的usb程序。FPGA芯片用的是ALTERA公司的，编程所用的软件为quartus和nios，USB芯片为CH376.-VERILOG HDL language written with usb program. ALTERA FPGA chip using the company s software program used quartus and nios, USB chip CH376.
uart
- USB与pc机串口通讯的程序，开发环境为quartus11.0.该源程序是仿照黑金的教程来做的。能够往串口调试助手上顺利发文件。-Pc USB and serial port communication program development environment for quartus11.0. The source is modeled black gold tutorial to do. Serial debugging assistant can go on successfully
StepMotor
- 实现两相四线步进电机的控制,实现速度的调节-Achieve control two-phase four-wire stepper motor
NEC_RC
- NEC编码红外遥控协议代码供参考，红外遥控工具-NEC remote control code
Tuner
- Tuner驱动代码开发示例，供参考，很有价值-Tuner driver source code
RC5
- Philips RC5 红外遥控协议源代码-Philips RC5 Remote control protocl code
ds18b20
- 2个单总线ds18b20的温度读取单片机程序-2 single bus DS18B20 temperature reading program