资源列表
Robot
- 一个基于C，实现红外遥控自动巡边自动机器人的程序-Based on C, infrared remote control to achieve automatic automatic robot program Inspected
MOTOCONTROL
- 一个基于c，附硬件四脚高低电平输入对应输出接图，实现电机自动控制的程序- A high and low legs corresponding to the input output interface Figure based c, attached hardware, to achieve automatic control
LED
- 一种基于C，实现超大屏幕LED的控制方案-Control scheme based on C, realization of large screen LED
oledPusartPflashPds3231
- stm32平台实现信号机交流滤波保护,OLED实时显示时钟、电流、电压、故障编号等信息。-stm32 platform signal AC filter protection, OLED display real-time clock, current, voltage, error number and other information.
upd7210-2.1
- NEC公司GPIB控制芯片uPD7210的驱动程序-uPD7210 driver
chengxu
- 有关飞思卡尔的2015年摄像头组的例程的一部分-Freescale routine
bsc
- AVR用于构建基于USB的GPIB控制器-Program acts as a system GPIB controller using USB
stm32-ATK-SIM900A-GSM
- stm32单片机控制，实现ATK-SIM900A进行gsm/gprs通信-stm32 MCU control, ATK-SIM900A were gsm/gprs communication
ILI9341_code
- 驱动芯片为ILI9341，控制器LPC2220，总线方式，数据宽度16位-Driver chip ILI9341, controller LPC2220, bus mode, data width 16，3.2TFT
BlueTooth_4.0_For_IAR-8051
- 蓝牙4.0防丢器CC2540源码-使用IAR 8051-BlueTooth_4.0_For_IAR 8051
TouchPad153_ver_A3
- AM8EB153 SOP-8 触摸按键程序-AM8EB153 SOP-8 Touch Key Demo Code
1
- 用TIM5的通道2（PA1）来做 输入捕获，并实现一个简单的电容触摸按键，通过该按键控制DS1的亮灭-With TIM5 channel 2 (PA1) do Input capture, and implement a simple capacitive touch buttons, lights by the button control to eliminate DS1