资源列表
3-14-8
- 51单片机开发的一个小程序 帮助大家学习使用 。希望能帮到你- 51 MCU development of a small program to help you learn to use. I hope you can help
uart_ip
- UART硬件描述语言代码，经过验证可用，符合spec协议-UART hardware descr iption language code, proven available, in line with the protocol spec
iicaUVM
- I2C硬件描述语言代码、验证环境以及说明文档，已通过验证-I2C hardware descr iption language code, documentation and verification environment, which has been verified
0
- STC15F104E单片机编程实现继电器通电后给4次信号，继电器吸合，不够4次不吸合，断电才断开-STC15F104E microcontroller programming after the relay is energized to achieve four times the signal, relay, 4 does not pull enough, power was disconnected
microcontroller
- STC15F104E单片机编程实现继电器通电接通24小时后断开5秒一直循环-STC15F104E microcontroller programming relay 24 hours after power is turned off 5 seconds has been circulating
Press-pull
- STC15F104E单片机编程实现按下吸合20秒断开-STC15F104E microcontroller programming Press pull off 20 seconds
relay
- 温控继电器，温度低于下线值关闭继电器，达到上线值打开继电器-Temperature control relay, the temperature is lower than the value turns the relay off the assembly line, to the value of on-line open relay
brushless_driver_2
- 无刷电机驱动程序。基于STM32，调用DMA和串口。环境为KEIL5。-brushless driver program,based on STM32, use the UART and DMA controller
BEEP
- 蜂鸣器模仿报警声，基于51单片机的蜂鸣器模仿报警声-The buzzer to imitate the alarm sound, 51 SCM buzzer alarm based on imitation
1
- LED灯摆动显示，LED左右摆动显示-LED lamp swinging display
UCOstolpc
- 这是本人调试的将Ucos系统移植到lpc系列单片机-This is my debug Ucos system will migrate to lpc series microcontrollers
i51
- 51实验板电路图 led灯，液晶，矩阵键盘，数码管等-The 51 experiment circuit board