资源列表
lm3s811-SPWM
- 通过lm3s811产生SPWM逆变电源的应用-SPWM inverter power generation applications through lm3s811
DMP-Test
- mpu6050的dmp库测试程序。通过dmp库直接输出姿态四元数。-mpu6050 the dmp library test program. Quaternion output directly through the dmp library.
STM32-MPU6050-serial
- 通过STM32的iic口读取mpu6050的数据,通过串口输出-Mpu6050 read data through the STM32 iic mouth
CNP_Monitor
- 淘宝上购买的miniAHRS配套的上位机软件。使用前请查阅说明，XP下可用，WIN7下3D显示有问题。-MiniAHRS Taobao to buy PC software package. Read instructions before use, available under XP, WIN7 the 3D display problems.
PID_data
- PID模拟。这个模拟主要是针对MARLIN固件中对热电偶的温度控制模拟。-PID simulation. This simulation is mainly for MARLIN firmware thermocouple temperature control simulation.
SPI_SlaveTest_7
- 改程序为STM32作为从机接收主机时钟后，向主机发送信号，并将norflash中的APP程序发送给主机接收的程序-As the reform process for STM32 receives the master clock, sending a signal to the host, and the APP program norflash sent to the host program received
WDT_demo_V101
- 该程序描述看门狗定时器的使用方法和寄存器配置问题，注意debug调试对看门狗不能做断点调试-The program describes the methods and the use of the watchdog timer register configuration issues, note the debug breakpoint debugging on the watchdog can not do
TIMER_demo_V101
- 该程序描述SD08（A12）的TIMER定时器的使用方法以及中断响应设置。-The program describes the SD08 (A12) to use the TIMER timer and interrupt response settings.
SPI_demo_V101
- 改程序描述SD08（A12）的SPI通信，分别实现了主从模式和1字节传输到16字节传输的不同方法，分别使用中断和查询两种接收方式-Change the program descr iption SD08 (A12) of SPI communication, respectively, to achieve the main transmission mode and 1 byte to 16-byte transmit different methods, namely the use of
master-and-serial
- 用于3维测量的3轴步进电机控制，搭载串口通讯-3-axis stepper motor control for three-dimensional measurements, equipped with serial communication
NORFLASH_demo_V101
- 该程序用于SD08（A12）操作norflash，读写时注意512对齐，2kbit为单位，INT接收数据。-This program is used to SD08 (A12) operating norflash, note 512 aligned read, 2kbit units, INT receiving data.
stm485
- 3485的c语言代码，能够实现485的接受和发送,可以用于stm8处理器上。-3485 c language code, to achieve acceptable and send 485 can be used on stm8 processor.