资源列表
Verilog135
- VERILOG实用小例，约135个，特别对于初学者很有用处-VERILOG Practical cases, about 135, particularly useful for beginners
ADC
- C8051F060 AD转换中断程序，示例程序分享-C8051F060 AD conversion interrupt program, sample programs share
F06x_SMBus_EEPROM
- C8051F060,IIC通讯子程序，读写24C08(EEPROM)程序-C8051F060, IIC communication routines, read 24C08 (EEPROM) program
lift
- PIC16F1936上写的一款电动工具的程序，最早是个美国老外写的，后来转交给我维护，里面包括PIC单片机的定时器，IO口，EEPROM，PWM等的操作及设置，采用最新的MPLAB XIDE编写。绝对有参考价值。-this is a program of battery powered tool, you can find the setting for TIMER,PWM,EEPROM and IO , it was complied on MPLAB XIDE and it is very
music
- 用单片机选择播放多段音乐，由单片机控制音乐的播放。-MCU selection play a plurality of pieces of music, played by SCM control music.
keyboard_12864
- 读取在键盘上按下的数值，显示在12864液晶屏上。-Read in numerical press on the keyboard, the display on the LCD screen in 12864.
filter
- multisim对各种各样种滤波器的仿真-The simulation of several filter Multisim
18b20_1602
- 18B20温度传感器，单片机控制显示在1602液晶屏上。-18B20 temperature sensor, single-chip microcomputer to control the display on the LCD screen in 1602.
18b20
- 18B20温度传感器，单片机控制显示在数码管上。-temperature sensor, MCU control in the digital tube display.
DHT11
- 单片机编程传感器dht11，可用于测量温度和湿度。-Microcontroller programming sensor DHT11, can be used for measuring temperature and humidity.
motor_controlling_based_on_ARM
- 该程序是基于ARM的电机控制程序，可以通过串口和中断方式控制-The program is based on ARM s motor control program that can be controlled through the serial port and interrupt
eda
- 采用 6 个数码管分别显示小时、分钟和秒的数值； (2) 计时方式可在 12 小时/24 小时之间切换； (3) 通过按键可以对 “时”和 “分”进行校时，同时秒计数器清零。-Using six digital tube display hours, minutes and seconds values (2) the timing mode can be between 12 hours/24 hours switch (3) may be on the when