资源列表
arduino-RFID-IR
- 运行于arduino上的程序，可同时识别RFID标签，和红的发射信号。需要硬件：RFID模块，IR红外接收头。 具体接线方式，文件内已给出。-Arduino running the program on, which can identify RFID tags, and red emission signals. Requires hardware: RFID module, IR infrared receiver. Specific wiring, has been given in th
chengxu
- 基于51单片机的超声波测距，带有温度补偿计算，精度达到0.5cm-51 microcontroller based ultrasonic ranging, temperature compensation is calculated with an accuracy of 0.5cm
cc2530-code
- 基于zigbee cc2530的模拟输入调试程序，给出了使用cc2530模拟输入所需配置的寄存器。可用。-Based on the analog input debugger zigbee cc2530, gives the desired configuration using cc2530 analog input registers.
code
- msp430g2553测量方波震荡频率的程序，可测量的范围为：小于65kHz。-msp430g2553 square wave frequency measurement procedures, the frequency range that can be measured: less than 65kHz.
IEC104_C_language
- 南瑞iec 104规约使用C语言使用于嵌入式编程-iec 104 protocol that used c !
test_oled
- 12864 OLED驱动可以工作在stm32系列arm上的源代码-oled driver 128x64 for stm32 mcu etc.
Nc-power-supply
- 用单片机STC12C4052 三位数码管实现 程控电源的控制按键 可以调整电压-Programmable power supply to achieve the MCU STC12C4052 three digital control buttons to adjust the voltage
vhdlcode
- mutibit flipflop for combining 50ff s in a single clock
ATMLH012
- 基于IIC总线控制，实现对ATMLHO12芯片的读写操作，主要内容包括：硬件电路的连接、工作时序、代码-Based on the IIC bus control chip to achieve ATMLHO12 read and write operations, the main contents include: connecting hardware circuits, timing of work, the code
6LMCWRTC
- 6热敏电阻测温数码管显示的单片机参考C语言源代-6 thermistor temperature digital display microcontroller C language source code reference
5AD-DAYYY
- AD-DA转换在C语言中的操作的单片机参考C语言源代 -AD-DA converters operating in the C language reference microcontroller C language source code
4-C51KZTFJSD
- C51单片机控制彩屏TFT及SD的单片机参考C语言源代-C51 MCU control TFT color screen and SD microcontroller C language source code reference