资源列表
CAN_Receive
- 飞思卡尔单片机CAN总线接收程序，适用于MC9S12DG128芯片-Freescale MCU CAN bus receive procedures applicable to MC9S12DG128 chip
STM8S-USB-master
- 这是一个stm8S003模拟USB键盘HID的程序，首先，通过中断来接收USB数据，接收完后，调用 void usb_rx_ok(void) 来应答或不应答，并识别数据包，把相应的状态写usb这个结构体里面。 然后，在主循环中不断的调用 void usb_process(void) 来根据 usb 里面的状态来做相应的动作。 设备描述符的发送是这样的：调用 void usb_send_data(uint8_t * buffer, uint8_t lenght)， 将描述符打包，放到 us
II2C
- 用VHDL语言实现II2C协议，用状态机写的。-Use of the VHDL II2C agreement with the state machine to write.
DVA9991-Dvd-MCU-Firmware
- DVA9991 Dvd MCU Firmware
mega16多通道程序
- 用于多通道的AD采集，每个通道可以独立控制，针对只有一个寄存器而配置多个AD通道的单片机，具有参考意义
STC_GY-30
- 这是专门在STC系列单片机上所编写的关于光照度传感器的一套源码资料！-This is specifically written in on STC series microcontroller information about light sensor of a set of source code!
C8051F340
- 这是光照度传感器在8051单片机上所写的源码及可执行文件，方便调试使用-This was written by a light sensor on the 8051 single chip microcomputer, the source code and executable file, convenient debugging use
BH1750_arduino
- 这是光照度传感器为BH1750_arduino所写的一套程序源码，内部右详细说明-This is a light sensor for the BH1750_arduino wrote a program source code, internal details right
AVR_GY-30
- 这是为AVR单片机编写的关于照度传感器的源码资料-This is for AVR single chip microcomputer to write about the intensity of illumination sensor information source
CCD_smart_car
- 线性CCD的源码编写,基于xs128单片机-The source code of the linear CCD, xs128 based single chip microcomputer
DS1302POLED
- 基于msp430f149的oled+万年历显示程序-Calendar display program based msp430f149 of oled+
LCD1602
- 基于msp430f149的lcd1602液晶显示程序-Lcd1602 LCD display program based msp430f149