资源列表
LED_twinkle
- MSP430利用32.768KHz倍频到25MHz，开启定时器中断，MSP430易学教程-MSP430 using 32.768KHz multiplier to 25MHz, turn the timer interrupt, MSP430 learn tutorials
web-http-STM32-W5100
- stm32 与W5100 内嵌网页，只要修改对应的IO就可以通过网页控制开发板上的LEd-stm32 and W5100 embedded web page, just modify the corresponding IO can be controlled through a web development board LEd
STM32-TFT-SOURSE
- stm32 官网例程，可以用在单片机开发，嵌入式开发的参考例程。-stm32 official website routines can be used in single-chip development, embedded development reference routines.
stm32-can--ex
- stm32 can收发，经过实践测试，收发正常。正常模式要两个板子。-stm32 can send and receive, through the practice test, send and receive normal. Normal mode to two boards.
USB2CAN
- usb to can ，can测试，c语言源码，可以做产品-usb to can, can test, c language source code, you can make the product
ADCaPLL
- 在FPGA上编写的通过SPI总线配置外部PLL芯片AD9518和ADC9268的程序，通过板级调试，验证可用。程序通过状态机实现，将需要配置的寄存器值转为SPI总线的数据格式发送出去。 -Configure external PLL chip AD9518 and ADC9268 via SPI bus program on FPGA written by board-level debugging, verification is available. Program through the
UART
- 在FPGA上编写的通过UART接口同上位机进行通信的程序，通过板级调试，验证可用。 -Written on the FPGA to communicate via UART interface ditto-bit machine program, through board-level debugging, verification is available.
ili9141
- ILI9341V底层驱动，可驱动BMP图片，默认240*320.经过测试。-ILI9341V underlying driver can drive BMP images, the default 240* 320. Been tested.
ltc2183
- 在FPGA上编写的通过SPI总线配置外部ADC芯片LTC2183的程序，通过板级调试，验证可用。程序通过状态机实现，将需要配置的寄存器值转为SPI总线的数据格式发送出去。 -Configure external ADC chip LTC2183 via SPI bus program on FPGA written by board-level debugging, verification is available. Program through the state machine, you
dac5686
- 在FPGA上编写的通过SPI总线配置外部DAC芯片DAC5686的程序，通过板级调试，验证可用。程序通过状态机实现，将需要配置的寄存器值转为SPI总线的数据格式发送出去。 -Configure external DAC chip DAC5686 via SPI bus program on FPGA written by board-level debugging, verification is available. Program through the state machine, you
ISO9141-2-source
- ISO9141-2协议，obd协议，C语言代码-ISO9141-2 agreement, obd protocol, C language code
ad9516
- 在FPGA上编写的通过SPI总线配置外部PLL芯片AD9516的程序，通过板级调试，验证可用。程序通过状态机实现，将需要配置的寄存器值转为SPI总线的数据格式发送出去。 -Configure external PLL chip AD9516 via SPI bus program on FPGA written by board-level debugging, verification is available. Program through the state machine, you w