资源列表
test_232
- 这里包含了FPGA的232串口调试程序，可供学习和借鉴-FPGA RS232 TEST
STM32_SDIO
- STM32的SDIO硬件配置，验证过，好用。只需简单修改-STM32 SDIO hardware configuration, validated, easy to use.Simply change
A
- 8位数码管时钟（实时时钟） - 库函数,8位数码管时钟（实时时钟） - 库函数-Eight digital tube clock (real time clock)- library functions,Eight digital tube clock (real time clock)- library functions
STM32_SPI_OLED
- stm32 oled 驱动 spi方式-stm32 oled drive spi.........
4路AD+OLED显示.rar
- 基于STM32F103RBT6的OLED程序，四路AD输出，并于OLED显示。
STM_32F2xx_Lib_V1.1.0
- ARM M3 STM32F2xx 库文件 -ARM M3 STM32F2xx Lib
AD01
- 软件置位启动AD转换，实现ADC模块16路通道的采样。采样模式采用顺序采样。AD采样的触发方式采用软件置位的方式-Software setting start the AD conversion, the realization of channel sampling ADC module 16 road.In a sequential sampling mode.AD sampling way of trigger with the method of setting software
EvPwm02
- PWM1和PWM2输出频率为1KHz的PWM波形。波形的占空比每隔1s变化5 ,范围在10 到90 之间。 -PWM1 and PWM2 output frequency of 1 KHZ PWM waveform.Waveform of the duty ratio changes every 1 s 5 , in the range between 10 and 90
LedFlash
- 通过使用CPU定时器来控制LED灯D3的亮和灭，间隔时间由CpuTimer0来控制。-Using of the CPU timer to control the LED lamp D3 on and off .The time interval is controlled by the CpuTimer0.
07_Sci02
- 使用SCIA模块和PC机进行串口通信，等待PC机上的串口调试软件向DSP发送数据，DSP接收到上位机发送的数据之后，将这些数据发回PC机，显示在串口调试软件中。-Using SCIA module and PC serial port communication, Wait for the PC serial debugging software to send data to DSP, after DSP receiving the PC sends data, send the da
uart_ttl_rk8003a
- 富士通编码模块（自己画底板，配合HDMI芯片sil9135）使用接口,-Fujitsu encoding module interface (HDMI chip after the class module)
14-LED
- led花样流水灯，各种花样，初级单片机学习者必选学知识。-led tricks water lights, all kinds of tricks, who must choose a primary MCU learning knowledge.