资源列表
msp430
- 发送：从msp430单片机 P1、P2 口输入按键信号， PC 机 RS232C 口接收。 接收：PC 机由 RS232C 口发送数字时，P4 口连接的数码管显示。需要发送十六进制数，例如， 十进制数 3，应该发送 03。 -Send: msp430 microcontroller from P1, P2 port input key signal, PC machine RS232C port reception. Receive: PC machine from the R
GPIO-control
- ARM GPIO控制,用于控制ARM的GPIO的输入输出-ARM GPIO control
PL2303
- （2） 激光枪固定在一机构上，可通过键盘控制激光枪的弹着点（用键盘设置激光束在靶纸上上下、左右移动一定距离-(2) fixed to a laser gun mechanism, a laser gun can be controlled by the keyboard of the point of impact (using the keyboard provided in the target of the laser beam up and down the paper, move ar
CP2102
- （1） 用激光笔改装激光枪，激光枪可受电路控制发射激光束，激光束照射于胸环靶上弹着点的光斑直径＜5mm；激光枪与胸环靶间距离为3m。-(1) modified by a laser gun laser pointer, the laser gun can be controlled by the circuit emits a laser beam, a laser beam is irradiated on the point of impact on the chest of the tar
CH340
- 设计一个能够控制激光枪击发、自动报靶及自动瞄准等功能的电子系统。该系统由激光枪及瞄准机构、胸环靶、弹着点检测电路组成，其结构示意见图-To design a control laser shot hair, automatic target and automatic targeting system and other electronic functions. The system consists of a laser gun and aiming mechanism, chest rin
Setup_JLinkARM_V458a
- 经过DH-CG410采集卡采集到图像后，我们得到了靶面的数字图像，即计算机系统所要处理的对象。-After DH-CG410 to the image acquisition card, we got a digital image of the target surface, which target computer system to be dealt with.
Infrared-reflection
- 红外反射式程序，利用调制解调方法进行红外线防干扰反射开关-Infrared reflection type of program, anti interference infrared reflection switch using the modulation and demodulation method
Alarm-clock
- 单片机闹钟程序，可调整时间，闹钟设置掉电闹钟保护-MCU clock procedures, can adjust the time, alarm clock setting power down alarm protection
g2553-three-piece
- TI工程师最重要的资料（基于msp430g2553的三件套）-g2553 three-piece
ds1302
- DS1302实时时钟，1602液晶显示出实时时间，调试好-DS1302 real time clock, 1602 LCD display time, good debugging
winhex
- 野火stm32单片机开发原理图，本图包含各个接口的功能原理等-Wildfire stm32 microcontroller development schematics, this figure includes features such as the principle of each interface
main_inverter
- 关于单相逆变器的2812编程，帮助学习SPWM，以及电流的PI闭环控制。-main inverter