资源列表
STM8S003_RN8209
- 开发环境IAR STM8S003驱动RN8209，对RN8209寄存器读写 可以通过UART将RN8209的寄存器值发送到上位软件，波特率96-IAR for STM8S STM8S003 R/W RN8209
HI3520D_Key_Drv
- HI3520D按键驱动程序，按键还分按下与释放，并有应用示例程序。-HI3520D key drivers, press and release the button is also divided, and the application sample programs.
SSRAM_by_Verilog
- ssram读写接口设计的详细资料，具有指导价值。包括了主要的读写源代码和时序图。-Details interface design of reading and writing of ssram，it have guidance value.Including the main source code to read and write and sequence diagram.
SSRAM_250M
- 本人编写的SSRAM高速读写工程，工程中包含了NIOS软核，利用Quartus的TimeQuest工具进行了时序约束，上班调试最高读写速率可达250MHz。-I write the SSRAM high-speed, speaking, reading and writing, engineering includes NIOS soft core, timing constraint is studied by using Quartus TimeQuest tools, work to de
keyboard
- Its having c program to perform keypad scanning. Means how to find key press exactly and using efficient code.
LED_drv
- 这是一个4412开发板上面LED的驱动，做嵌入式的朋友如果有兴趣可以-This is a 4412 development board LED drivers, so embedded friends can see if you are interested
Test Sw Hw Bawin
- Is a code for test Hardware of sofwarere de bawin
89C51-LCD
- 一个简单的 AT89C51单片机 的LCD驱动程序- AT89C51 LCD Driver Program.
DA
- 通过编程对DSP28335的DA进行输出四种不同的波形，分别是方波、三角波、锯齿波、正弦波。-By programming the DA output DSP28335 four different waveforms, respectively, square, triangle wave, sawtooth, sine wave.
ePwm
- 通过对DSP28335的ePWM外设进行设置，使pwm输出一定占空比的方波信号-Through the ePWM DSP28335 peripherals set to make certain pwm duty cycle square wave output signal
T-speed
- 利用CCS编写的DSP工程，代码主要实现的功能就是对一段位移进行T型速度规划，在板子上跑拥有很不错的速度和位移响应曲线-Use of CCS projects written in DSP code main function is to carry out some T-displacement velocity planning on running board has very good velocity and displacement response curve
430
- 430单片机实现电子秤的程序,其实就是采集模拟信号，硬件部分是小信号的放大。-my English is poor