资源列表
22
- 利用定时/计数器T1产生定时时钟,由P1口控制8个发光二极管,使8个指示灯依次一个一个闪动，闪动频率为10次/秒(8个灯依次亮一遍为一个周期)，循环-The use of timer/counter T1 timing clock generated by the P1 port to control 8 LEDs, making eight lights were flashing one by one, the flashing frequency of 10 times/sec (8 li
11
- 利用定时/计数器T0从P1.0输出周期为1s的方波，让发光二极管以1HZ闪烁，设晶振频率为12MHz-The use of timer/counter T0 from P1.0 output cycle square wave 1s, so that the light-emitting diodes 1HZ blinking, set the crystal frequency is 12MHz
nrf24l01
- 利用单片机控制NRF24L01无线模块，实现数据的无线收发-SCM control NRF24L01 wireless module, wireless data transceiver
Multiple-18b20-
- 利用单片机控制多个18b20，并将温度显示在1602 LCD上面-SCM control multiple 18b20, and in 1602 LCD temperature display above
Photosensitive-resistance-test
- 利用adc，将光敏电阻的值数字化，并显示在数码管上-Use adc, the photosensitive resistor values digitized and displayed on a digital
traffic-lights
- 利用二极管模拟交通灯的控制，基于51单片机实现-LED traffic lights to control the use of simulation, based on 51 MCU
18b20
- 利用51单片机及温度传感器18b20，实现温度测量，串口传输到上位机显示-51 SCM and temperature sensor 18b20, temperature measurement, serial transmission to the host computer display
s3c2440interupe
- 利用汇编语言开发s3c2440，初始化芯片使用外部中断实现按键流水灯-Using assembly language development s3c2440, initialize the chip implementation key light water use external interrupt
dynamic-display
- 51单片机动态扫描数码管，利用锁存器实现多个数码管显示-dynamic display
static-state
- 51单片机芯片静态显示数字，功能简单，51入门的好资料-static status display
interupe01
- 51芯片外部中断，有源代码详细的解释，这个工程一起，打开可用可下载-51 chip external interrupt
second-chronograph
- 51制作秒表，利用51定时器制作简单的秒表，文件还有源代码工程和仿真图-51 SCM stopwatch