资源列表
StandSerialPIC18F2480
- 基于PIC18F2480的标准串口测试程序，程序使用硬件串口方式，局域MPLAB开发环境，程序使用的波特率是19200,1位起始位，8位数据位，1位停止位，编译器使用的是PIC18编译器，编译器没有选择正确将导致编译不成功，使用前需要先下载PIC18的编译器。-PIC18F2480 based standard serial test procedure uses hardware serial port, local MPLAB development environment, the pro
source
- 本程序采用F2812作为控制器，实现6个小led灯一次亮灭，使用GPIOA0-A5输出口-The program uses F2812 as a controller, 6 small led lights to achieve a light off, use GPIOA0-A5 output port
ucos28335_no_task_inside
- DSP28335下ucos本系统，已经移植好，直接编译可用-DSP28335 ucos under this system has been ported good, compiled directly available
rtl8192_8188CU_linux_v3.0.tar
- relteck 的rtl8192_8188CU 原代码，最通用的Wifi方案，市场上带WiFi的产品多用该方案-relteck of rtl8192_8188CU original code, the most common Wifi solutions, products on the market with WiFi multi-purpose of the program
BTF350
- 关于c8051f350所有程序-All programs on c8051f350
STM32
- 数控直流电源，通过4*4按键输入所需电压，PWM调节BUCK电路的开关管的导通时间调节到你所需的电压-NC DC power supply via 4* 4 keypad enter the desired voltage, PWM BUCK regulator circuit switch conduction time adjusting to your desired voltage
Touch
- 基于zigbee的触摸扳源代码，需要用IAR打开。-Based on the zigbee touch pull the source code, need to use IAR to open.
PWM
- 基于zigbee的PWM的c程序源代码，用IAR加入工程。-Based on zigbee PWM c program source code, using IAR to join the project.
Motor
- 基于zigbee的电机的调试代码，需要用IAR打开。-Based on the zigbee motor debugging code, need to use IAR to open.
FM1702SL
- 基于zigbee的FM的c程序源代码，需要用IAR打开。-Based on the zigbee FM c program source code, need to use IAR to open.
89c52-LED-shumaguan
- 基于89c52的数码管显示，单只数码管循环显示0-9-Based 89c52 digital display, single loop digital control display 0-9
Hall
- 基于zigbee的霍尔传感器源代码，用IAR打开。-Hall sensor based on zigbee source code, use the IAR to open.