资源列表
output-pwm
- //利用TA0.1在增计数模式的比较器模式的输出模式中的置位/复位模式下输出频率为500HZ的占空比为25 （高电平占25 ）的PWM波-//Use TA0.1 in up-counting mode comparator mode output mode is set/reset mode, the output frequency is 500HZ duty cycle of 25 (High 25 ) of the PWM wave
out-put-fangbo
- //利用TA的定时器功能输出频率为500HZ的方波-//Use the TA timer function output frequency is 500HZ square wave
IOinterrupt
- MSP430G2553的IO口的一个小中断程序，可以用按键出发中断，实现LED灯闪烁-MSP430G2553 IO mouth of a small interrupt routine, you can use buttons departure interruption, blinking LED lights
ADC10--test
- 实现MSP430G2553的AD采样，可以读出电压值。-Achieve MSP430G2553 AD sampling, can be read out voltage.
TA-capture
- MSP420G2553捕获模式,可以捕获一个方波，并输出和捕获波形一样频率的方波。-MSP420G2553 capture mode, you can capture a square wave, and the same output and capture waveform frequency square wave.
uCGUI-TFT6448
- 以C8051F120单片机系统为实例，描述了uC/GUI在单片机系统的实验程序。-C8051F120 SCM system as an example to describe the uC/GUI experimental procedures in the SCM system.
W5200_TCPS
- STM32F103RBT6和W5200网络芯片的服务期端的测试程序，减少了很多不必要的设置，测试更方便-W5200 STM32F103RBT6 and end of service network chip testing procedures, to reduce a lot of unnecessary settings, the test is more convenient
W5200_TCPC
- 自己用的STM32F103RBT6与W5200的TCP测试程序，单片机作为客户端使用。-W5200 own use STM32F103RBT6 with a TCP test program, microcontroller as a client.
Q
- 求模程序。。没有调用ip核，根据数学算法，逼近的思想，来编写的求模程序-verilog square
a
- 用verilog实现除法器，调用了ip核，不仅有源代码，还有测试程序的时序编写-verilog ise divider
myinput
- 自己用的LPC2368与中显的TFT3224液晶的16针连接程序，能显示句子，图形。-Own use LPC2368 with the explicit TFT3224 LCD 16-pin connector procedures, can show sentences graphics.
OPTIC-SWITCH
- 利用ADUC831实现1*4光开光控制 -Use ADUC831 achieve an optical switch light control* 4