资源列表
uart-TEST
- TI 554 Uart接口测试程序，采用CPU TI5402 s812tr 8.24 发送测试程序。9600波特率 s812TRRE 8.24 发送接受程序。9600波特率 s802.out 8.28 发送接受程序。9600波特率,在操作过程中LCR=1B常常变化为0，需注意是否干扰问题。 S828.OUT 8.28 发送接受程序。38400波特率,数据端信号完好，抗干扰。-TI 554 Uart interface testing procedures using
_01H_COTAONUC100_MCU
- 本程序是基于NUC100单片机的串口开发，串口接收利用的是超时接收，另外本软件是基于一个单任务的操作系统，省去了延时函数占用整个系统的时间-This procedure is based on the development NUC100 MCU serial, serial receiver receives the use of overtime, In addition the software is based on a single-tasking operating system,
F2812
- matlab开发的F2812源代码,演示ADC如何与EPWM关联。方便初学者了解-F2812 code developped by MATLAB
16K2
- 430F149扫描4X4键盘并将键值在1602液晶上显示-430F149 scan 4X4 keypad and LCD display keys in 1602
main
- 430F149单片机用从P2.3和P2.4输出的PWM波形驱动LED闪烁P2.3口输出方波的占空比为75 P2.4口输出方波的占空比为25 -430F149 microcontroller P2.3 and P2.4 output from the PWM waveform drive LED flashes P2.3 port output square wave of duty cycle 75 P2.4 port output square wave of 25 duty cyc
project5
- 用430F149控制AD9851的程序 。-AD9851 with 430F149 control procedures.
10-LCD1602
- 51单片机中在lcd1602中显示按键输入的内容。-51 single-chip display key input in lcd1602 content.
tic6201
- uCOS 在68hc11处理器上的应用。-the application of uCOSii on the 68hc11 platform.
SignalTap-II
- FPGA应用开发入门与典型实例代码，典型实例9 SignalTap II 功能演示-FPGA Application Development and Typical examples of code, typical examples 9 SignalTap II functional demo
STM32_SD_DEMO_V3
- STM32的SD卡演示程序，基于V3.0的st库文件。-SD card STM32 demo program, based on the st V3.0 library file.
KeyManage
- 按键扫描和简单处理。其中按键扫描是封装好的程序，方便用户移植，开发环境使用的是keil，单片机使用的是stm32f103vc系列的。-Key scan and simple treatment. Where key scan is packaged program, user migration, the development environment using keil, microcontroller using stm32f103vc series.
STM32_ADC_V3
- STM32的ADC采集应用演示，基于V3.5的ST库文件。-The ADC acquisition applications STM32 demo V3.5 ST-based library files.