资源列表
zero
- 第七届飞思卡尔智能车比赛，我们的小车泡得还算稳定，速度有一米三左右。-Seventh Freescale smart car contest, our car bubble was fairly stable, the speed of one meter three or so.
DAC124S085
- msp430通过SPI口控制12微DA转换器DAC124S085，程序中input_reg_content都是0x700，则四通道输出都是2.2V.-msp430 through the SPI port to control 12 micro-DA converter DAC124S085, program input_reg_content are 0x700, then the four-channel output is 2.2V.
MCP2822_drive
- MCP4822驱动，用C编写，主控芯片51单片机，-MCP4822-driven, written in C, the master chip 51,
H1750FVI
- msp430控制光强传感器H1750FVI，并将光强度转换值送到8位LED显示。-msp430 control the light intensity sensor H1750FVI, and converts light intensity value to the eight LED display.
2
- 通电启动后，默认状态是读出E2PROM中保存的电机走纸的长度并显示，显示的走纸长度可以通过键盘重新设置-After power-up, the default state is stored in E2PROM read the paper feed motor length and display, the displayed paper feed length can be reset via the keyboard
R8CL35_TimerC_PWM_Ext8M_Div8
- 瑞萨芯片学习代码，对于入门的有一定的帮助-Renesas chip learning code, for the entry of some help
M32
- 用于实时监控一定范围内的烟雾变化，并把状态通过无极性二总线传输给主机。-For real-time monitoring of a range of smoke changes, and the state of polarity of the second bus through transmission to the host.
M2
- 实时监控并接收主机发出的控制命令，启动相应的设备。-Real-time monitoring and control commands issued by the receiving host, start the appropriate equipment.
M1
- 连接在无极性的二总线上，用于监控压力开关等输出开关量信号的设备。-Promise of the two connected on the bus for monitoring pressure switch output switch signal equipment.
MSP430-control-TLV5613
- 这个是用MSP430单片机驱动12bit并口数模转换器TLV5613的例子程序。程序中sent_data = 0x0fff，输出模拟电压为最*值。-This is done using the parallel port MSP430 microcontroller driver 12bit DAC TLV5613 example program. Program sent_data = 0x0fff, the analog output voltage to the maximum ref
UniStrongDemo
- wince gps demo 调用gps的接口实现定位，路径分析-wince gps demo
Adept-IOExpansion
- digilent ioexpansion