资源列表
i2c
- 本文档是为单片机初学者写的I2C编程示例程序。使用的单片机硬件是最通用的stc89c52单片机，编程语言为c语言。-This document is written for the microcontroller I2C programming examples for beginners program. Using microcontroller hardware is the most common stc89c52 microcontroller c language programmi
uCOS-II
- 基于uc、os的学习资料，对于了解操作系统的工作原理很有帮助。-some important information about UC/OS systerm
51MCUPBMP085PLCD1602
- 基于单片机的温度高度海拔计，BMP085和LCD1602实现，经过测试完全正确。-Microcontroller-based temperature Altitude meter, BMP085 and LCD1602 realized, tested entirely correct.
jiaotongdeng
- 利用单片机设计交通灯控制系统，能显示状态倒计时：红灯50秒，绿灯80秒，黄灯3秒，能利用本机键盘重新设置各个状态（相位）时间；-The use of single-chip design traffic light control system that can display the status Countdown: red 50 seconds, 80 seconds green, yellow 3 seconds and can use the keyboard to reset the
paobiao
- 一个简单的电子跑表， 使用单片机中的定时计数器；上电或复位键后显示000.0 当按下启动键时，作为跑表使用，显示范围是: 000.0-999.9秒， 当按下停止键时，跑表停止运行，并保留所停位置的时间显示不变。当按下清零重计数键时，马上跳回000.0 重新开始计数。-A simple electronic stopwatch, timer counter using microcontroller After power-up or reset button displays 000.0 w
shuzizhong
- 一个简单的电子时钟，能够显示当前的时间。 用LED显示；初始时间由键盘设定，并设定一个按键来切换显示的格式：12小时制和24小时制。具备闹钟功能，当设定的时间到达时，通过蜂鸣器播放一段音乐。 -A simple electronic clock that can display the current time. LED display initial time from the keyboard settings, and set a button to switch the di
shuiwei
- 一个简单水位控制系统， 使用继电器+LED模拟水位控制；采用数码管显示水位状态 采用继电器控制抽水状态。 -A simple level control system, using the relay+LED analog level control using digital display level status using relay control pumping state.
spwm
- 使用51系列设计一个简单SPWM波形产生器；能通过按键调整输出频率 SPWM的载波频率为2KHZ -Use of 51 series design a simple SPWM waveform generator through the buttons to adjust the output frequency SPWM carrier frequency of 2KHZ
ADC_DAC_FMF_converters_vhdl.tar
- This library contains VHDL 1076 models of analog to digital and digital to analog converters. They use the VITAL packages but are not VITAL compliant.
verilog_fifo.tar
- Verilog FIFO model independent
32-bit-parallel-interger-bit-
- 32 bit parallel integer bit
serial-multiplier-using-generic-components
- Serial multiplier using generic components