资源列表
nrf905_5keys_51
- 用于51单机上连接NRF905无线模块的SPI通信，并且可以用按钮输入值进行相应的控制以及程序的便携。并且本资料分了master主控端 以及slave接收端的程序，经过本人的验证十分好用。-51 stand-alone connected NRF905 of wireless module SPI communication, and can use the buttons to enter the value of the corresponding control and program p
programme
- 1. 用51单片机内部的定时器实现秒计数，用两个七段LED显示器上显示秒时间，用一个按键控制秒表的计数和清零。 2. 按键入口选用P1口。 3. 按键采用软件去抖动。 4. 七段显示器接口采用串行口扩张并行口，显示方式为静态显示。 -With 51 MCU internal timer to count seconds and display the second time with two seven-segment LED display, a button control
Temp
- 温度检测，此程序用于通过51单片机控制ds18b20温度传感器检测温度。-Temperature detection, this program for 51 single-chip control DS18B20 temperature sensor detects the temperature.
fifo_code
- FIFO读空标志和写满标志的计算，memory分配-FIFO read empty flag and filled with flag calculation, memory allocation
test7
- 51单片机控制FY-50-6448屏实现通过字库读取英文字符-51 single-chip control FY-50-6448 screen font to read English characters
ARM-Boot-Coding
- ARM编程基本知识，BOOT代码流程，OS中断程序编写-The basic knowledge of of the the ARM programming, BOOT code processes, OS interrupt program to prepare
DSP-F2812
- DSP F2812控制直流无刷电机源代码-DSP F2812 control brushless DC motor source code
camera_fifo_ctrl
- camera异步接口中FIFO控制部分的源代码-FIFO control section of the source code in the asynchronous interface, camera
20-Door-Bell-Designed-by-Timer
- 用定时器来设置门铃，每当按键按下的时候，单片机记录端口为低电平，导通门铃响铃电路，发出预置的铃声。-Use a timer to set the bell, when the button is pressed, the recorded port is low, conducting doorbell ringing circuit, a preset tones.
project
- 51单片机控制SD卡，并将SD卡中的字符分割存入数组，为下一步开发做准备。-51 MCU control SD card and SD card characters split into an array, to prepare for the next development.
ARM_Bios_analysis
- ARM BIOS总体结构及部分源代码分析 Makefile文件-ARM BIOS overall structure and part of the source code of the Makefile
19-TMR1-Counter-LT-10000
- 用工作于计数方式的TMR1实现按键或脉冲计数，每按键一次记录为1，可以累加和复位。-With the work in the way of counting the TMR1 key or pulse counting, every button once for a record 1, can be accumulated and reset.