- matlabengine VC＋＋环境下调用MATLAB程序实现数字信号处理的方法
- I2Cv2.1 I2C 总线规范 I2C 总线的IC 不只帮助了设计者它们也使设备厂商得到很多益处
- PIC1 PIC
- ecc 椭圆曲线算法的实现 VC++程序 源代码 elliptic curve
- ug349 k to ours in terms of the design goals. They implemented a UDP/IP offload engine based on a commercial TCP/IP Offload Engine and this work has 35 better performance as compared to a host
- covdonestThe 鼠标打字程序
资源列表
clock_1
- kiel c51开发，单片机的液晶显示时间程序，，适用于51单片机，11.0592mhz的时钟-kiel c51 development, single-chip LCD procedures applicable to the 51 single-chip, 11.0592mhz clock
msp430shiboqi
- 示波器程序 内部AD 采样最高200k 通道0 X Y 可以简单拉长-Oscilloscope program internal AD sampling up to 200k channel 0 XY can simply elongated
USB_M
- Keil4开发，可在电脑上看到用ARM控制、USB传输的鼠标移动情况。-Keil4 development, you can see on the computer with ARM control, USB transfer mouse movement.
bujindianji--2803
- 单片机 2803 驱动步进电机 正反转 加减速-SCM 2803 drive stepper motor acceleration and deceleration
16*16点阵屏设计
- 16*16点阵屏设计,含源程序,原理图,及PROETUS仿真等 ,是比较好的学习开发资料
usb
- 在SEED实验板上实现的USB程序，芯片采用的是TMS320F28335-USB using complete on SEEDBoard based on TMS320F28335
i2c_rtc
- 在SEED板子上实现的I2C程序，采用的芯片是TMS320F28335-I2C using complete on SEEDBoard based on TMS320F28335
adc_dma
- 在seed实验板上是实现的ADC_DMA，芯片采用的是TMS320F28335-ADC_DMA using methord on SEEDBoard Based on TMS320F28335
uart_lcd
- 基于FPGA的UART通信，并用LCD(1602)显示通讯状态和通讯的数据。通过在ALTERA公司生产的DE2-115开发板上运行，证明此程序稳定可靠。时钟为50MHz，语言为VHDL,状态机。-FPGA-based UART communication, and LCD (1602) show the communication status and data communications. DE2-115 development board by ALTERA Company product
flash
- 在sedd板子上实现的FLASH程序，采用的芯片是TMS320F28335-FLASH using on SEEDBoard Based on TMS320F28335
shujuchuanshu
- 用51单片机做的数据传输，代码完整，非常好-With 51 single-chip data transmission, complete code, very good
Timer1ISRMode2
- Timer1ISRMode(51单片机代码)很实用，适合初级学者用-Timer1ISRMode (51 MCU code) is very practical, suitable for junior scholars