资源列表
atmega8
- atmega8 PWM信号产生程序用ATmega8的T/C1和T/C2可以产生三路PWM 信号.-are atmega8 PWM signal generator
科远DCS项目程序
- 科远DCS项目程序，常规控制逻辑，设备保护逻辑，正常信号组态处理过程。
Flash-program
- 东芝单片机 flash programmer 软件-Toshiba microcontroller flash programmer software
51proc-experimental-routines
- 周立功单片机\51proc实验例程\RC500读卡模块实验\controller-Luminary Micro \ 51proc experimental routines \ RC500 the reader modules experiment \ controller
RS232Pprotues
- RS232多机通信。附protues仿真图。主机和从机源码工程。keil工程-RS232 multi-machine communication. Attached protues simulation diagram. Master and slave source project. keil project
LPC2300_ROUTING_1
- LPC2300技术笔记上册例程，需要的人自然知道-Routine of the LPC2300 technical notes on the book, naturally know people in need
jiankongzongduan
- 这是本人设计的一个智能家居模型的监控总端的源代码，经过试验，程序都是可以使用的-I designed a model of smart home monitoring end source code, are tested, the program can be used
PID_K
- PID控制测K值程序，本程序原本是在飞思卡尔光电组中的一个测K值另外写的程序。但是可以很方便的移植到任何需要PID的地方-PID control measured K value of the program, the program originally Freescale photoelectric group measured K value write another program. But can be easily ported to any need PID
znFAT-test
- 这是znFAT在51单片机上测试的完成代码，是学习文件系统的好资料-This is the completion of the test code znFAT 51 MCU, learning good information of the file system
dianji
- 单片机：数字密码锁设计，输入键，修改密码，设置密码键，-SCM: digital code lock design, the Enter key, change the password, set a password key
STC51_HMC5883L
- HMC5883L角度传感器STC51单片机源码。 附HMC5883L角度传感器文档资料及使用方法-HMC5883L angle sensor STC51 microcontroller source. Attached HMC5883L angle sensor documentation and use
03_EvPwm01
- dsp2812产生pwm波形程序，控制步进电机正反转与调速-dsp2812 generates pwm waveform control stepper motor with speed control