资源列表
stdio
- 模拟标准输入输出函数，将数据输出到指定端口(Analog standard input and output functions to output data to a specified port)
24 彩屏例程
- ARM下的彩屏编程,包含3.2寸，3.5寸及新版3.2寸彩屏的编写程序。(how to use colorful LCD)
Close
- 软启动，SVPWM，ADC采样及滤波，FOC，是根据TMS320F2833XDSO应用开发与实践的例子写的，已调试(Soft boot, SVPWM, ADC sampling and filtering, FOC, is based on the example of TMS320F2833XDSO application development and practice, and has been debugged)
openfoc
- 永磁同步电机开环程序，有软启动，svpwm,adc采样及滑动平均滤波和低通滤波(Permanent magnet synchronous motor ring opening program, soft start, SVPWM, ADC sampling and sliding average filter and low pass filter)
PMSM_soft_50Hz_new
- 完整的永磁同步电机矢量控制程序，带软启动，DAC输出，SCI,EPWM,ADC...(A complete vector control program for permanent magnet synchronous motor, with soft start, DAC output, SCI, EPWM, ADC...)
UBOOT
- SD 卡下 UBOOT 的制作和编程 QSPI FLASH，以防程序就容易丢失(SD card UBOOT production and programming QSPI FLASH, in order to prevent the program is easy to lose)
User_IP
- 如何在 VIVADO 中创建用户自定义的IP(How to create user defined IP in VIVADO)
3.sharp memory lcd
- 使用efm32zg开发夏普的memory lcd，实现单色显示(Using efm32zg to develop SHARP's memory LCD to realize monochrome display)
6.加速度计
- 使用efm32zg开发加速度，adxl345作为加速度的输出芯片(Using efm32zg to develop acceleration, adxl345 as an acceleration output chip)
2.实体按键
- 使用efm32检测按键是否被按下，使用扫描方式(Use efm32 to check if the button is pressed, using a scan)
1.LED闪烁
- 使用efm32zg实现led的闪烁，gpio的控制(The use of efm32zg to realize the flicker of LED)
spi - sd
- 使用nrf52832，通过文件系统操作sd卡， sdk14.0，将此文件直接放到examples\ble_peripheral文件夹下即可(Using the nrf52832, the SD card is operated through the file system. Sdk14.0, put this file directly under the examples\ble_peripheral folder)