资源列表
daoshujishiqi
- 利用51单片机 实现99s倒数计时器，按键1实现个位的设置，按键2可以实现十位的设置，st启动倒数计时-using 51to enable 99s jishi
CPU_VHDL
- 这是实现一个8位和16位cpu的VHDL代码，虽然支持的指令比较少只有20多条，但对于学习CPU的布线架构很有帮助-This is achieved by an 8-bit and 16-bit cpu VHDL code, although only a relatively small instruction support more than 20, but for learning routing architecture CPU helpful
Headtracker
- Headtracker using sensors: ADXL345 (acc), ITG3200 (gyro), HMC5843 (mag) with data fusion using an extended kalman filter on STM32F10x and data output via USB to PC. Code (sensor reading, filter) written by me. Validated on real hardware.
MPC5602D_FlexCAN-2013-12-01-CAN-OK
- MPC5602D的开发程序；包括调好的FlexCAN通讯和中断；是开发汽车电路的好CPU哦-MPC5602D development process including tuned FlexCAN communication and interrupt was to develop a good car circuit CPU oh
HX711AD
- HX711，里面有接线图，和c51程序，怎么计算重量-HX711 reference drivers (C51)
IIC
- 由于51单片机没有IIC硬件接口，所以通过时序来模拟IIC时序图来实现功能！-Because no IIC 51 MCU hardware interface, so the timing to simulate the IIC sequence diagram to realize the function of!
CEPARK-IAR_Stm32Adc
- stm32自带adc IAR环境 验证可用-stm32 comes adc IAR environment verification available
CEPARK-IAR_Stm32Gpio
- stm32GPIO IAR环境 点亮LED灯 可用-stm32GPIO IAR environment lit LED lights available
Mini51DESeriesBSP_CMSIS_v3.00.001
- 详细说明：Numicro Mini51系列开发包，超完整，格式规范，很适合蕴其它程序借鉴。KEI开发环境下编程，包括I2C,串口，GPIO,中断，定时器等，适用于所有M051系列的单片机。M051,M052,M054,M058,M0516-Numicro M051 series development package, ultra-complete format specification, it is suitable for to Yun other program to learn fro
Project-Proteus
- proteus File list(Click to check if it s the file you need, and recomment it at the bottom): USERSYM.LIB wyh.BAK wyh.IDX wyh.LIB USERDVC.IDX USERDVC.LIB USERPKG.IDX USERPKG.LIB-proteusproteusFile list(Click to check if it s t
codeandPCB
- 基于STM32的四旋翼直升机代码及PCB打包-Based on the STM32 four rotor helicopter code and PCB package
updata
- 基于msp430单片机的远程自升级代码及上位机软件-Msp430 microcontroller-based remote from the upgrade code