资源列表
ClockSync
- 基于COMTEX-M3的IEEE1588,irigB对时的源程序，包括GPS对时程序，并将对时的结果写入FPGA中-Based COMTEX-M3 of IEEE1588, irigB on time source, including GPS for the program, and writes the results when the FPGA
CAN_59
- 微处理器控制CAN通信的程序，用于SJA1000的正常收发，可用于工程。-Microprocessor-controlled CAN communication program for normal transceiver SJA1000 can be used in engineering.
FLASH_16
- DSP外部烧写flash程序，可将任意的程序烧写到16位flash中，工程烧写可应用-DSP external programming flash program, any program can be programmed to flash 16, the project can be applied to programming
testpot
- 用C语言自编实现的可达到UDP级的以太网层协议，可随意ping。-Ethernet can achieve UDP layer protocol level C language self realization, free ping.
eth1f
- 用C语言自编实现的可达到UDP级的以太网层协议，可随意ping。可烧写入6713B中运行-Ethernet can achieve UDP layer protocol level C language self realization, free ping. 6713B is written to run to burn
DSP28335-I2C
- 基于DSP28335的I2C读写EEPROM程序。此程序为应用程序非底层程序，可以作为参考提供I2C使用方法。-DSP28335 of I2C EEPROM-based literacy program. This procedure for the application of non-underlying process can be used as a reference to provide I2C use.
MPC5634M-eSCI-PLL-getchar-CW29
- MPC5634串行通信接口例程，已在开发板上调试成功，可以直接使用。-MPC5634 serial communication interface routines, has been in development board debugging success, it can be used directly.
MPC5604B_SD
- MPC5604的SD读写程序，在开发板上调试OK，有需求的拿走。-SD MPC5604 s literacy program, the development board debugging OK, there is a demand away.
MPC5634M-FlexCAN-SimpleTX
- MPC5634的CAN发送程序，接收通过中断，与之类似-MPC5634 CAN-sending program, received by an interrupt, with similar
MPC5604B_DSPI
- MPC5604的SPI通信程序，有需要的可以随便拿走了-MPC5604 The SPI communication procedures, there is a need can easily take away
MPC5604B_UARTreceive
- MPC5604的串行通信接口接收程序，已调试好，有需要的可以拿走了-MPC5604 serial communication interface to receive the program, has been debugged, the need to be able to take away
xiaoche
- 基于stm32单片机的小车控制及驱动程序-Based on the stm32 MCU control car and driver