资源列表
FOC_PMSM_STM32CONTROL
- 基于STM32，针对永磁同步电机的FOC控制，正弦波控制，支持带霍尔位置传感器和不带霍尔位置传感器两种电机。-Based on STM32, FOC control for permanent magnet synchronous motor, sine wave control, support with Hall position sensor and Hall sensor without two motors.
wav_player_on_sam7s
- wave player for at91sam7x256 in keil
usb-device-massstorage-project-at91sam7x-ek-iar.z
- When an EK running this program connected to a host (PC for example), with USB cable, the EK appears as a USB Disk for the host. Then the host can format/read/write on the disk. If there is SDRAM on the EK, the disk can be up to 10M so that read/wr
usb-device-hid-transfer-project-at91sam7x-ek-iar.
- The USB HID Transfer Project will help you to get familiar with the USB Device Port(UDP) and PIO interface on AT91SAM microcontrollers. Also it can help you to be familiar with the USB Framework that is used for rapid development of USB-compliant cla
usb-device-hid-mouse-project-at91sam7x-ek-iar
- The USB HID Mouse Project will help you to get familiar with the USB Device Port(UDP) and PIO interface on AT91SAM microcontrollers. Also it can help you to be familiar with the USB Framework that is used for rapid development of USB-compliant class
CortexM4_TRM_r0p1
- very useful for learning about arm cortex m4 and its instruction set
485_modbus
- STM32F10X运用485通信MODBUS协议进行数据传输控制！-STM32F10X use 485 MODBUS communication protocol for data transmission control!
20140603_PWM_TIM_LCD
- STM32F103，最小系统启动，主频72Mhz。开Tim2中断作为控制，开4路10KhzPWM以及普通IO口，外接16为并行LCD显示器，用外部Ram方式读写。 IAR6.3 工程，用Jlink调试。-STM32F103, minimum system startup, clocked 72Mhz. Open Tim2 interrupted as a control ISR, open 4 10Khz PWM and common IO port, external 16-bit par
ourdev_702527S9EBCB
- stm32 小车四轮驱动 循迹控制 液晶屏显示代码-stm32 trolley wheel drive traction control LCD display code
usb_hid20140827
- 最近在用STM32，遇到了很多问题，这算是调试的STM32的USB-HID-Recently with the STM32, encountered many problems, which can be considered to debug the STM32 USB-HID
key
- STM32F407 PD0连接到K3,PD1连接到K2,PD2连接到K1,PD0、PD1、PD2配置为线中断模式，当K3、K2、K1按下时，进入线中断处理函数，LED状态取反。-STM32F407 PD0 connected to the K3, PD1 connected to K2, PD2 connected to the K1, PD0, PD1 and PD2 configured for line interrupt mode, when the K3, K2, K1 press e
EFT_Diagnose_C
- Source code EFT_DIAGNOSE