资源列表
Camera
- 在ARM开发板上实现摄像头采集信息的功能，并在液晶屏上显示-Camera on ARM board
TouchPanel
- ARM9上面实现触摸屏的初始化和一些简单功能-ARM9 touchscreen achieve the above initialization and some simple functions
IIC
- 通过IIC总线实现通信，可以简单测试通信结果-To comunication by IIC bus
Demo_STM32_Rx
- 基于STM32的SI4432射频接收程序-Based on the STM32 SI4432 radio receiving program
STM32F107PlwipPucosPucgui
- stm32f107上移植ucos+lwip+ucgui-On stm32f107 transplant ucos+lwip+ucgui
ffs9-Template
- stm32f103上移植文件系统ffs9，编译环境MKD-Portable File System on stm32f103 ffs9, compiler environment MKD
lcd-3-2-at91sam7x256-adc4
- tft lcd whith arm lpc
keyboard
- 键盘任务与显示任务联合实验程序，：在实验中，利用五条短消息来完成键盘任务和显示任务之间的通信。程序中用两个按键分别控制数字窗口是否需要显示出来，用两个按键对数字窗口的水平位置进行调整，用10个按键分别输入10个数字，这些数字显示在窗口中。- Keyboard and display tasks experimental procedures, in experiments using five short message communication between the keyboard to
daoshujishiqi
- 利用51单片机 实现99s倒数计时器，按键1实现个位的设置，按键2可以实现十位的设置，st启动倒数计时-using 51to enable 99s jishi
CPU_VHDL
- 这是实现一个8位和16位cpu的VHDL代码，虽然支持的指令比较少只有20多条，但对于学习CPU的布线架构很有帮助-This is achieved by an 8-bit and 16-bit cpu VHDL code, although only a relatively small instruction support more than 20, but for learning routing architecture CPU helpful
Headtracker
- Headtracker using sensors: ADXL345 (acc), ITG3200 (gyro), HMC5843 (mag) with data fusion using an extended kalman filter on STM32F10x and data output via USB to PC. Code (sensor reading, filter) written by me. Validated on real hardware.
IIC
- 由于51单片机没有IIC硬件接口，所以通过时序来模拟IIC时序图来实现功能！-Because no IIC 51 MCU hardware interface, so the timing to simulate the IIC sequence diagram to realize the function of!