资源列表
swrr114
- 德州仪器的CC2541 keyfob的PCB文件,蓝牙开发-Texas Instruments CC2541 keyfob PCB document
IAR_for_ARM_installation_instructions
- IAR_for_ARM安装、使用说明，适用于所有使用IAR开发环境的人员-IAR_for_ARM installation instructions, applicable to all persons using the IAR development environment
remote-monitoring
- This paper focuses on classes of remote monitoring and control applications where important functionality is required at low cost a new methodology for monitoring and control is proposed where the processing is based on firmware on an off the s
LT-ARM214X-Use-TCPIP-to-Get-Data
- 使用LPC214X系列arm通过TCP\IP协议完成数据的采集以及传输。-Use LPC214X series arm to complete the data collection and transmission via TCP \ IP protocol
615pro_fpga_driver
- LPC3250与FPGA接口程序，FPGA作为ARM的SDRAM使用-LPC3250 and FPGA interface program, FPGA using ARM as SDRAM
nrf24l01
- 基于51单片机的nrf24l01参考实例程序，希望对开发有所帮助。压缩包包含这些程序：多对一发送，一对一发送，一对一接收，一与多收发，一与一收发。-ON划词翻译ON实时翻译 NRF24L01 51 MCU based on reference examples of procedures, hope to help to develop. Compressed package that contains the program: to send, send one to one, on
GPS
- GPS定位及轨迹记录器设计报告,内涵原理图、实物照片、源程序C代码-GPS position and track record of design report, meaning the schematic, real photos, source C code
KeilWigglerAndH-JTAGjianmingjiaocheng
- keil 下使用wiggle 和H-Jtag的详细的简明教程。前提是keil必须支持RDI接口。-keil use wiggle and H-Jtag concise detailed tutorial. Keil must support the premise that RDI interface.
sam7X_dbgu
- Keil SAM7 dbgu basic project code
sd120_refrigeration_0c
- 基于pic单片机的制冷算法处理,可以把目标温度控制在4度之内-Pic microcontroller-based refrigeration algorithm processing, the target temperature can be controlled within 4 degrees
embOSforSTR7
- This project should serve as an \"easy start\" with embOS. All pathes are relative to the project file. You should therefor be able to copy the entire directory (including all subdirectories) to any location on your harddrive.
ili9325-lcd
- STM32测试程序通用IO口LCD3.2英寸驱动测试 -STM32 test program general IO mouth LCD3.2 inch drive test