资源列表
xlcd
- pic18的 12864lcd头文件-the pic18 the 12864lcd header files
ADC
- ARM mini-2440 A/D 模数转换器驱动使用示例程序。-ARM mini-2440 A/D analog driver using the sample program.
ALU
- 用verilog编写的4位ALU，由算术运算模块、逻辑运算模块、选择模块组成
TR24B驱动
- 2.4G无线模块的驱动
049bujindianji
- 步进电机的编程，对于刚刚入手单片机的孩子有用-Stepper motor for children just starting microcontroller
ZigBee-switch
- ZigBee遥控开关模块部分 本程序实现 1. 利用12信道可以实现开门动作；2. 随时接收来自遥控器的控制命令； 3. 实现实时闭合动作和断开动作；-ZigBee remote control switch module parts of the Program Implementation 1. Use of 12 channels can open the door movement 2. Ready to receive control commands from the remo
chushi
- 飞思卡尔智能车光电组原始程序，128的，稍微改下就能跑圈了-The original program of Freescale Smart Car photoelectric group, 128, slightly changed to be able to lap
ARM9S3C2410
- Tp-wn321在ARM9 S3C2410平台的移植.txt
MIPS_Power
- This MIPS program takes a number and power and gives the result of the specified power of that number. Ex: Number = 10 Power = 2 Result = 1-This MIPS program takes a number and power and gives the result of the specified power of that number
SHTxx--C51
- 用C51编写的系列温湿度传感器SHTxx的访问代码。采用两个引脚控制SHTxx的读写，通过数据计算以后用串口输出。-C51 series prepared by temperature and humidity sensors SHTxx the access code. SHTxx the use of two-pin control of the reading and writing, through the use of data after the serial output.
nandflash
- tornado开发的s3c2410的nandflash驱动代码-development by tornado s3c2410 nandflash driver code
FLASH
- 2516flash程序,底层读写操作，经过实际测试，可以直接使用-2516flash program