资源列表
SSP
- NXP 新推出ARM7处理器芯片LPC2478的SSP模块的例程代码。编译环境为IAR。-Code for the SSP module of NXP s LPC2478 chip.The compile environment is IAR.
interrupt
- 这是ARM9 linux 2.4.X 中断驱动开发例子，想学LINXUX 驱动开发不妨下载参考，测试OK
CAN
- Stm32f103 can bus demo example-Stm32f103 can bus demo example功能开发
MSP430F149_RFID
- MSP430F149读写卡参考例程, 可以读写RFID射频卡片的程序。 -RFID Reader for MSP430F149
inverter-SPWM
- STM32单片机主控器，推挽全桥逆变器，SPWM控制，查找表生成SPWM波形，闭环，输出220V/50Hz交流电-STM32 microcontroller master, push-pull full-bridge inverter, SPWM control, look for 220V/50Hz AC table generating SPWM waveform, the closed-loop output
User
- 基于stm32的电梯显示源代码 这是毕业设计，略显粗糙，请大神指点-based on stm32 elevator display src
serial
- S3C44B0x上面的N皇后问题程序，使用串口（UART0）作为输入和输出。-S3C44B0X above N Queen s problem, the use of serial port (UART0) as input and output.
API
- Exemplo acender led ARM7
STM322xG_EVAL
- LCD interface example for STM32 ARM Cortex M3 platform. The interface is through FSMC.
ARMkechengsheji
- C++编写的ＡＲＭ可控万年历使用ARM ADS1.2编译-ARM C++ write controlled calendar using ARM ADS1.2 compile the
MCP2515_driver_s3c2440based
- 本驱动程序在s3c2440上实现了两路基于SPI的CAN总线控制器。两通道可以并行，并使用外部定义的两个信号量来通知接收任务收到CAN总线帧，并将其存入预先定义的队列中（帧定义在CAN总线控制器驱动程序的头文件中）。CAN总线控制器的中断引脚分别连接到ARM的EINT3和EINT8_23上-The driver s3c2440 achieved a two-way SPI-based CAN bus controller. Two channels can be parallel, and us
LPC-L2294-BLINK-LED-ECLIPSE
- lpc 2294 example blink led eclipse