资源列表
LCD2051
- 用51单片机开发的红外接收与红外发射程序-51 Single Chip with infrared receiver and infrared emission process
SPI
- This is NUC900 Stand-alone LIB API18 sample code for IT expert.
pro01
- This a simple and clear project that presents the steps used to design a board in Proteus-This is a simple and clear project that presents the steps used to design a board in Proteus
DS1820
- DS18B20，广泛用于温度测量，给出了可行的源代码，方便测温-DS18B20, widely used for temperature measurement, given a feasible source code, to facilitate temperature
ARMPLinux
- ARM+Linux启动过程分析 同体系结构的处理器来说Linux的启动过程也有所不同。本文以S3C2410 ARM处理器为例-failed to translate
low-pulse-triggered
- 在方式2计数期间，OUT端为高，当减到0，OUT端输出低脉冲。本实验用此低脉冲触发微控制器的中断。方式3是方波发生器方式，计数值N为偶数时，输出为对称方波，前N/2期间，OUT输出为高，后N/2期间，OUT为低。本实验中，时钟CLK信号由ALE接入，设Q0为输出频率，Q1为ALE频率，则：计算初值=Q1/Q0.-During the counting mode 2, OUT terminal is high, when reduced to 0, OUT-ended output low pul
i2c
- lm3s9b92 source file from stellaris sdk
nand_flash_me1.2
- 基于ARM9的NAND FLASH（large page）的驱动，包括读写和擦除（在数据区可剩余区），读取ID号等主要功能。
s3c2440_linux_examples
- s3c2440 development board embedded Linux examples
PIC18F1320--bootloader
- PIC18F1320单片机通过串口下载的bootloader源程序（C语言）-PIC18F1320 microcontroller through the serial port to download the bootloader source code (C language)
ext_int.rar
- lpc2468外部中断源程序，四个外部中断，实现功能是每个按键按下led达到相应闪烁频率,EXT INT FOR LPC2468
GPS2
- 这是一个基于ARM7的GPS处理源代码，里面有C/C++的代码-This is an ARM7-based GPS processing source code, there are C / C code