资源列表
RTC_2103
- lpc2103 驱动内部RTC -lpc2103 drive internal RTC
StepMotor
- 一种ARM控制下的步进电机的加速控制的源代码-ARM under the control of a stepper motor acceleration control of the source code
arm-timer
- 一个ARM7的定时器程序,程序员通过该程序可以了解ARM7的编程方法,启动过程,地址映射等基本概念和实现方法-an ARM7 timers procedures, the procedures adopted by programmers can understand ARM7 programming methods, the process started, address mapping of such basic concepts and methods
SENDRTC
- 嵌入式ARM编程，实现实时时钟RTC，涉及PLL，发送信号-ARM embedded programming, real-time clock RTC, involving PLL, send signals
Wireless-2.4Ghz-primer-0.1
- STM32 and CC2500 Wireless 2.4GHZ.
29132-Sound-Impact-Sensor-v1.0
- ARM based NOise sensor
90460_frt_ocu-v10
- This is an program for the MB90460 series. It initializes the output compare units0-5. Also the 16bit Free RunningTimer. -This is an program for the MB90460 series. I t initializes the output compare units0-5. Als o Free RunningTimer the 16bit.
rf_contol
- 单片机89C51F300控制初始化代码,keil4环境开发，初学者很好的资料-SCM 89C51F300 control initialization code, keil4 environmental development, good information for beginners
IOmon3
- 利用386保护模式将DOS实模式下的PC总线I/O操作（in/out）实时捕捉到内存并可以显示在屏幕上。可用于ISA/VESA/PCI插卡及相关软件的输入/输出调试、I/O性能/行为分析和反汇编。Version 3增加了连续相同I/O操作的压缩记录功能，大大提高了内存利用率。同时提供了一些编译、测试脚本和BC3.1工程文件供大家在BC3.1下进一步开发。
counter
- Modify the solution of question 1 to have a down/up counter as follows: · RA2= 0 Counter is disabled. · RA2= 1 Counter is enabled: o If there is negative edge signal at pin RA3 then counter counts up. o If there is negative edge signal at pin
128128
- 128 彩屏测试代码,实现51单片机对128*128彩屏的控制盒显示。-128,128 color screen test code
OLED
- 在RVMDK环境下的STM32 OLED实验 内有详细代码说明-RVMDK environment STM32 OLED experiment Code Descr iption