资源列表
node1
- CAN总线通讯，基于arm,可以用于测试-CAN bus communication, based on the arm, can be used to test
liunx-student
- 这是我学习arm9时自己总结的一些常用命令和知识-This is when I learned arm9 summary of some of their knowledge of common commands and
LINUX下的USB-uploader
- LINUX操作系统下的USB-uploader-USB-uploader in LINUX Operation System.
RTC
- 初始化并运行 RTC，然后每隔1 秒钟读取一次时间值，并通过串口向上位机发送，上 位使用EasyARM 软件的仿真万年历窗口进行显示。-Initialize and run the RTC, and then every 1 second read time and sent through the serial port up crew, upper use EasyARM software simulation calendar display window.
EXTINT
- Ext interrup LPC17-Ext interrup LPC17xx
bootloader
- ARM 编程\\bootloader原码-ARM programming \\ Bootloader source
TDA8007
- tda8007 sample code for runnig sam module
12_TWI(IIC)
- MEGA16的TWI总线的应用，具体是读写可变电阻AD5161-MEGA16 wirte OR read AD5161
flashtest
- 基于三星44b0的flash程序，包括基本操作
AnteeoBee_20060218
- his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run \"make\" from the console in echomaster and ech
EasyJtag
- JTAG的驱动程序，一般都是用在相对应的嵌入式ARM处理器上，这个事实用在LPC2210上面。-JTAG drivers are generally used in relation to the embedded ARM processor, with the fact that the LPC2210 above.
Interrupt
- arm7\EasyARM1138例程，Interrupt(中断编程)-arm7 \ EasyARM1138 routines, Interrupt (Interrupt Programming)