资源列表
serial
- 基于arm s3c2410下的串口设备驱动-Under the arm s3c2410-based serial device driver
2ADCs_DMA
- 基于CORTEX-M3 内核的STM32两路ADC采集例程 -CORTEX-M3 core-based STM32 two of the ADC acquisition routines
nios_ram
- nios 中读写sdram的程序，适用于epc2 cyclone二代FPGA板子-Nios SDRAM read and write the procedures applicable to epc2 cyclone II FPGA board
LPC2378-I2C
- LPC2378的IIC应用模块程序！可直接使用！-LPC2378 application modules process the IIC! Can be used directly!
PortLCD
- LPC2378的LCD应用程序，对学习LPC278的LCD功能有很大的帮助！-LPC2378
USBHost
- LPC2378的USB应用程序，对学习LPC278的USB功能有很大的帮助！-LPC2378
1381driver
- 本程序是完成的HT1381的驱动程序，定义SPI的三个端口后，可直接调试。我在仪表的时钟中得到成功应用！-This procedure is completed driver HT1381, the definition of the three SPI ports, may directly debugging. I clock in the instrument has been successfully applied!
rs
- Reed-Solomoon 纠错算法C语言的实现，在ARM嵌入式平台MLC NAND flash 驱动验证过。-Reed-Solomoon correction algorithms in C language to achieve, in the ARM embedded platform for MLC NAND flash driver verified.
ADC_OneADC0
- ARM2290AD程序,包含所有的程序,调式通过-ARM2290AD procedures, including all of the procedures, mode through
exp3_3
- 为ARM的一些结构化代码，非常的通用，编程时只需将这些代码拷到相应工程中即可-For some of the structure of ARM code, very generic, just programming code Kaodao corresponding project can
ARMexample
- 包括ARM 的各功能模块的代码，非常详细-Including ARM various functional modules of code, very detailed
455207-jtager-0.1.0.tar
- jtager 源码 支持arm7 和 arm9 等ARM CPU,能够读取CPU 寄存器,内存,FLASH-jtager source to support the ARM7 and ARM9, such as ARM CPU, able to read the CPU registers, memory, FLASH