资源列表
444444
- 单片机按键测试和595的连接和编程，采用飞思卡尔单片机的完美利用。-SCM key test and connecting and programming 595
IR
- 用单片机实现红外接收发送的源码，是基于NEC协议的，包括发送，接收，学习，显示等功能-IR receiver with MCU sends the source, is based on the NEC protocol, including sending, receiving, learning and display functions
125K-IDreader
- 125K ID读卡器解码。采用STC11F02单片机对125K ID读卡信号采集并且解码验证输出。-125K ID card reader to decode. Using STC11F02 125K ID card reader microcontroller decodes the signal acquisition and verify the output.
USBFPGA
- 这个事usb芯片cy7c68013和赛科龙2fpga的开发板原理图，可以实现高速的数据通讯和上位机，可以480mb的速度传输数据可以组成100m的逻辑分析仪-This thing usb chip cy7c68013 and race Kelon 2fpga development board schematics, can achieve high-speed data communications and PC, you can transfer data at speeds of 100m
北航操作系统试验1
- 北航操作系统试验1，有详细说明文档，仅供参考。
LCD
- LCD亮度调节，基于STM32开发环境， 测试可用-STM32 lit LED
modbus_rtu
- modbus协议程序，调试通过，可以正常使用-modbus protocol program, debugging through
Electromagnetic--program
- 飞思卡尔电磁组可跑程序，速度2.5米，可深入开发，位移算法简单可靠-Freescale electromagnetic group can run the program, the speed of 2.5 meters, can further development, displacement of the algorithm is simple and reliable
S3C2440
- S3C2440 中文版芯片手册（1-27章）-S3C2440 DATASHEET
Embedded-System-Design
- 由彼得·Marwedel嵌入式系统设计 1.介绍 2.规范 3.嵌入式系统硬件 4.嵌入式操作系统、中间件和调度 5.实现嵌入式系统:硬件/软件合作设计-Embedded System Design By Peter Marwedel 1. Introduction 2. Specifications 3. Embedded System Hardware 4. Embedded Operating Systems, Middleware, and Sched
02-RTC
- sample RTC stm32f103 vet6
Transplantation-experiments
- 基于uC/OS系统在STM32上的移植，主要是多任务的实现-Based on uC/OS systems on the STM32 transplantation is to achieve multi-tasking