资源列表
CPU_VHDL
- 这是实现一个8位和16位cpu的VHDL代码，虽然支持的指令比较少只有20多条，但对于学习CPU的布线架构很有帮助-This is achieved by an 8-bit and 16-bit cpu VHDL code, although only a relatively small instruction support more than 20, but for learning routing architecture CPU helpful
daoshujishiqi
- 利用51单片机 实现99s倒数计时器，按键1实现个位的设置，按键2可以实现十位的设置，st启动倒数计时-using 51to enable 99s jishi
keyboard
- 键盘任务与显示任务联合实验程序，：在实验中，利用五条短消息来完成键盘任务和显示任务之间的通信。程序中用两个按键分别控制数字窗口是否需要显示出来，用两个按键对数字窗口的水平位置进行调整，用10个按键分别输入10个数字，这些数字显示在窗口中。- Keyboard and display tasks experimental procedures, in experiments using five short message communication between the keyboard to
lcd-3-2-at91sam7x256-adc4
- tft lcd whith arm lpc
ffs9-Template
- stm32f103上移植文件系统ffs9，编译环境MKD-Portable File System on stm32f103 ffs9, compiler environment MKD
STM32F107PlwipPucosPucgui
- stm32f107上移植ucos+lwip+ucgui-On stm32f107 transplant ucos+lwip+ucgui
Demo_STM32_Rx
- 基于STM32的SI4432射频接收程序-Based on the STM32 SI4432 radio receiving program
STM32F4_TIM-BASE
- STM32F407下的基本定时器的使用例程！-The use of basic timer STM32F4 routine!
IIC
- 通过IIC总线实现通信，可以简单测试通信结果-To comunication by IIC bus
TouchPanel
- ARM9上面实现触摸屏的初始化和一些简单功能-ARM9 touchscreen achieve the above initialization and some simple functions
Camera
- 在ARM开发板上实现摄像头采集信息的功能，并在液晶屏上显示-Camera on ARM board
main
- 这是用msp430编写的不同声调发声的程序-It is written in a different tone audible msp430 procedures